FURNITUREBOX APOLLO User manual

APOLLO
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips, advice
and assembly video or visit
furniturebox.co.uk/club/apollo
SCAN ME

• Check you have all the components and
tools listed.
• Remove all fttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from
the work area, small parts could cause
choking if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly.
In some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
TWO
PERSON
MAXIMUM
CAPACITY 100Kg
45 MINUTE
BUILD
IMPORTANT
STEP

Follow us on Instagram
@furniturebox_uk
STEP 2
Slide piece (2), then piece
(3) over threaded rods.
Fixed position with wooden
pins B.
STEP 1
Place the table top (1) upside
down on a clean at surface.
Screw four threaded rods
A into the inserts on the
underside of the table.
ATTENTION: Be careful
not to over-screw beyond
the thread stoppers on
thethreaded rod.

www.furniturebox.co.uk
STEP 3
Slide piece (5), then
piece (3) over threaded
rods. Fixed position
with wooden pins B.
STEP 4
Next Slide piece (2) on. Then place
the base (4) upside down over the
rods. Place a washer over each of
the rods. Using the box spanner F
tighten a nut E at the end of each
rod.
FULL ASSEMBLY INSTRUCTIONS
STEP 5
ATTENTION: With help, carefully
turn the table around to complete
assembly.

www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.