FURNITUREBOX CALLA User manual

CALLA
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips, advice
and assembly video or visit
furniturebox.co.uk/club/calla
SCAN ME

• Check you have all the components and
tools listed.
• Remove all ttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

ONE
PERSON
www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly.
In some cases more fittings may be supplied than are required.
IMPORTANT INFORMATION
MAXIMUM
CAPACITY
150Kg
30 MINUTE
BUILD
Rear Legs = Angled Front Legs = Straight
IMPORTANT: 1 package contains x2 front legs and the other package contains
x2 rear legs. One leg from each box makes up x1 chair. The legs at the front of
the chairs are straight and the rear legs are angled outwards.

Follow us on Instagram
@furniturebox_uk
STEP 1
First, connect the 2 leg pieces together. Use 2 x
washer [A] followed by screw [E] through the holes
in the leg pieces, and secure on the other side
using 2 x washer [A] followed by spring washer [B],
then nut [D]. Tighten using both Allen key [G] ad
spanner [F].
Front Legs are straight
Rear legs are angled outwards
Please use one leg from each pack in the box.

www.furniturebox.co.uk
STEP 2
Place the back and seat
cushion part [A] upside
down over the edge of a
stable table to work on.
Attach the legs to the
chair base. Align the tabs
in the leg frame with the
holes in the chair base.
Secure using washer [A]
followed by spring washer
[B] then bolt [B]. Tighten
with Allen key [G].
FULL ASSEMBLY INSTRUCTIONS
STEP 3
Carefully ip the chair onto its
legs. Check for stability. Your
chair is now ready to use.

www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.