FURNITUREBOX LIRA User manual

LIRA
EXTENDING TABLE
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips,
advice and assembly video or visit
furniturebox.co.uk/club/lira
SCAN ME

• Check you have all the components and
tools listed.
• Remove all fittings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its final
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more fittings may be supplied than are required.
IMPORTANT INFORMATION
45 MINUTE
BUILD
MAXIMUM
CAPACITY 100Kg
TWO
PERSON

Follow us on Instagram
@furniturebox_uk
STEP 1
Use a clean, flat, soft surface
to avoid any bumps or
scratches.
Place your tabletop [3]
face-down on the flat
surface.
Connect the extending
mechanism [4] - align the
pre-drilled holes and connect
using 2x washer [D] followed
by 2x bolt [C] - 1 one on each
side.
STEP 2
Add 4x feet [G] to the
bottom of the leg
pieces [1] and [2]

Follow us on Instagram
@furniturebox_uk
STEP 3
Connect the table legs [1] and
[2] together using 1 x washer
[B] followed by 1 x bolt [E] and
tighten with Allen key [F]
Do not fully tighten yet
as you will need some
manoeuvrability.
STEP 4
Connect the legs to the
tabletop.
Align the table legs with
the pre-drilled holes in
table top. Attach using
2x washer [B] followed
by bolts [A] in each table
leg (8 in total).
Once the legs are
secured, you can
go ahead and tighten all
the screws, including at
the connecting point
between the legs with
Allen key [F].

Follow us on Instagram
@furniturebox_uk
STEP 5
Carefully, and with help, turn
your completed table over so
it’s now the correct way up.
Ensure stability.
To extend, release catch on
either side of table and gently
pull table leaves apart.
Your table is now ready to
use.

www.furniturebox.co.uk

WHAT THE GUARANTEE COVERS
 
e.g. lose metal threads
 
e.g. bonding/glue

e.g. legs bending

 •
 
..
 
 
 
 


e.g. the frame of the
product
ACTIVATE YOUR GUARANTEE ONLINE
scan this QR code with your phone to read
the full guarantee on line and register your
product. It only takes a moment to fill out.
Or visit: furniturebox.co.uour-guarantee