FURNITUREBOX AMALFI User manual

AMALFI CONSOLE
TABLE
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips,
advice and assembly video or visit
furniturebox.co.uk/club/amalconsole
SCAN ME

• Check you have all the components and
tools listed.
• Remove all ttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
45 MINUTE
BUILD
MAXIMUM
CAPACITY 100Kg

Follow us on Instagram
@furniturebox_uk
STEP 1
Assemble on a clean, at soft surface to avoid any bumps or
scratches. Connect the 4 side panels by slotting the 2 x side panels
[2] into the 2 x end panels [3]
STEP 2
Secure the frame using
2 x washers [B] followed
by 2 x screws [A] on
each of the 4 corners,
top and bottom. We
recommend not
tightening the screws
until they are all in
place. Once they are,
tighten with Allen key
[C]. Then screw in 4 x
feet [E].

www.furniturebox.co.uk
STEP 3
Flip the table frame
over so it sits on its feet
and add the 4 x non-slip
tabletop connector pads
[D].
FULL ASSEMBLY INSTRUCTIONS
STEP 4
Carefully, with help, lower the tabletop [1] onto the frame. Check
stability. Your console table is now ready to use.

www.furniturebox.co.uk
www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.