FURNITUREBOX LEONARDO 6 User manual

LEONARDO 6
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips,
advice and assembly video or visit
furniturebox.co.uk/club/leonardo-6
SCAN ME

• Check you have all the components and
tools listed.
• Remove all fttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from
the work area, small parts could cause
choking if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly.
In some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
TWO
PERSON
MAXIMUM
CAPACITY 100Kg
45 MINUTE
BUILD
GLASS

Follow us on Instagram
@furniturebox_uk
STEP 1
Use a clear, at, soft surface to
avoid bumps or scratches. Place
the table top on the oor with the
metal discs facing up. Screw 4 x
rods [A] in to the metal discs.
STEP 2
Place the table legs over
the rods on to the metal
discs. Use 4 x nuts [B] to
secure table legs to table
top. Repeat for all 4 table
legs. Do not fully tighten
yet as you will need some
manoeuvreability.

www.furniturebox.co.uk
STEP 3
Add feet [C} to bottoms of table legs.
Connect all four legs together in the middle using the connecting
piece [H], washers [D] screws [E]. Tighten with Allen key [G].
Once connecting piece [H] is secured, you can then tighten all the
table legs to the table top with wrench [F].
STEP 4
Carefully, and with help,
turn your completed
table over so it’s now the
correct way up. Ensure
stability.
FULL ASSEMBLY INSTRUCTIONS

www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.