FURNITUREBOX VENICE User manual

VENICE
DINING TABLE
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips, advice
and assembly video or visit
furniturebox.co.uk/club/venice-round
SCAN ME

• Check you have all the components and
tools listed.
• Remove all fttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
TWO
PERSON
MAXIMUM
CAPACITY 100Kg
45 MINUTE
BUILD
GLASS

Follow us on Instagram
@furniturebox_uk
STEP 2
Slot connecting plate [G] between
the table legs and align holes with
holes in table legs.
Secure the legs to the connecting
piece [G] using 4 x bolt [B].
Once all legs are connected to the
table top and to the connecting
plate [G}, go ahead and fully
tighten all the bolts.
STEP 1
Use a clear, at, soft surface to avoid bumps or
scratches.
Place table top [1] face down on a at surface.
Align holes in the top of the table legs [2] with
the rectangular connection plates on the table
top. Connect legs to table top with 4 x bolt [A]
and 4 x washer [D] per leg. Use Allen Key [E].
Don’t fully tighten these bolts yet, to allow for
some manoeuvrability.

www.furniturebox.co.uk
STEP 3
Add the foot pads [C] to the
other ends of the legs.
STEP 4
ATTENTION: Carefully, and
with help, ip the table onto
its feet. Check stability. Your
table is now ready to use.
FULL ASSEMBLY INSTRUCTIONS

www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.