Furuno FM-3000 Instruction manual

DSC Position Polling with
FM-3000 and NavNet VX2
When any NavNet VX2 display is connected to the FM-3000 VHF radio, DSC
position reports can be received from another DSC capable VHF transceiver, then
shown on VX2's plotter as a waypoint. This capability allows two or more vessels
to transmit their position to each other via VHF, then record that position
information as a waypoint on the VX2's plotter.

Connection Diagram, 10.4" VX2
WHT
GREEN
YELLOW
BLACK
RED NMEA In RCA Jack - White wire from Plotter
to Center Conductor (+) and Black wire from
plotter to Outer (-)
000-117-603 Cable to
NMEA Port 2
White NMEA OUT RCA Jack - Yellow wire from
Plotter to Center Conductor (+) and Green wire
from plotter to outer (-)
Use Optional 000-117-603 Cable to connect the VX2 to
the RCA type connectors on the back of the FM-3000.
Set the VX2's NMEA port to output RMC and GGA.

Connection Diagram, 7" VX2
WHT
GREEN
YELLOW
RED NMEA In RCA Jack - White wire from Plotter
to Center Conductor (+) and Shield wire from
plotter to Outer (-)
000-144-418 Cable to
data 3
White NMEA OUT RCA Jack - Yellow wire from
Plotter to Center Conductor (+) and Green wire
from plotter to outer (-)
Use Optional 000-144-418 Cable to
connect the VX2 to the RCA type
connectors on the back of the FM-3000.
Set the VX2's NMEA port to output
RMC and GGA.
SHIELD