Gate Basic 56-280 User manual

GATE Rehab Development AB
Isberga Säteri, 333 91 Smålandsstenar
Phone [phone]
Fax [phone]
E-mail [email protected]
www.gaterd.se
Maintenance and refurbishment
1
4
3
2
1. Armrest- ensure that the glide protection/end caps are free from
damage and fitted correctly.
2. Seat/softseat- is complete and without damage. There should be
no sharp edges.
3. Footrest- is complete and can be adjusted. Make sure that the clips
are complete and tightened.
4. Wheel- should spin easily. Check that the wheels are correctly
tightened in the frame.
Regular checks
Maintenance
The commode is made of steel tubes (outer/inner coated) and aluminium.
Exposed details that haven’t been coated are made of aluminium/stainless
steel. The commode can be cleaned with normal cleaning agents (could be
cleaned in an autoclave 85 degrees). Check that the chair is not damaged
and there are no loose parts.
Art 56-280 / 121001
56-280 Shower Commode
Basic
56-280 Shower Commode
Basic

a) The footrest can be height-
adjusted when removing the
clip (see figure 3) and the
footrest can be positioned to
required height (don’t forget to
refit the clips)
b) The footrest can be angled
at a side by gripping at B- lift
upwards/swing
c) The footrest plate could be
turned upwards (c1) and/or
angled (c2) accordingly.
Manual instruction Basic
Height adjustment (1)
You can adjust the chair in two
ways- either when the commode
is standing on all wheels- or on it’s
side.
Adjusting the front wheels- loosen
the footrest clips (a-green clips) and
the telescope wheel (b-grey clips)
Adjust the telescope wheel to
required height (1), insert the GREY
clips (the lowest hole)
Position the footrest to required
height- tighten with GREEN clips.
Adjusting the rear wheels- loosen
the telescope clips GREY clips.
Adjust the telescope wheel to
required height- insert the GREY clips
in the lowest hole in the frame.
When all the adjustment has been
made- ensure that the CLIPS (a+b)
have been mounted correctly= the
clips are fitted correctly to the frame.
1
3
5
Sanitary pan (5 & 6)
The sanitary pan is pushed from the
rear side between the seat and the
panholder according to figure 5-6.
Make sure that the sanitary pan
is pushed on top of the panholder.
Also make sure that the sanitary
pan will be in the correct position in
relation to the seat.
Footrest (2 & 3)
Caution
Read the instruction carefully before
using the commode.
• Theprescriberisresponsiblethattheproductissuitablefortheuser.
• Max.userweightis150kg.
• NeverstandontheBasic.
• Cautionistobetakenwhenthegroundisunevenandalsowhen
passing thresholds or similar obstacles.
Locking wheel (4)
All the wheels are braked/locked.
Push lower part to brake (A).
Push upper part to release brake
(B)
4
B
A
7
There is a 2 year warranty on possible manufacturing faults
(does not include wear and tear).
Warranty
656-280 Shower Commode
Basic
2
a
1
b
B
c2
c1
Mounting the backrest (7)
Attach the backrest around the
backframe – lock with the snap.
Adjust to required position.
Make sure that the opening for the
armrest is fitted towards the opening
in the backrest.
a
b