GRI GT10 User manual

Made in U.S.A.
WARRANTY: One year warranty against workmanship, material and factory defects.
GEORGE RISK INDUSTRIES, INC.
G.R.I. PLAZA
KIMBALL, NE 69145
WWW.GRISK.COM
TOLL-FREE 1-800-445-5218
TOLL-FREE 1-800-523-1227
[phone]
FAX [phone]
E-MAIL: [email protected]
WWW.GRISK.COM
Gate Mount
Pool Alarm
GT10
Closed Loop
Microprocessor controlled
Weather resistant for outdoor use
Instant on or 7 sec. delay models available
Low Battery Indicator
Closed Loop 410P switch set
with 5 . 2 conductor cable
The GRI Gate Mount Pool Alarm was designed as an
aid for prevention of an unattended access to a pool/
spa area by a small child. Monitoring all gates with Closed
Loop magnetic reed switches, the Gate Mount Pool Alarm
will sound an alarm should anyone too small to manage the
adult pass through feature attempt access to the pool/spa area. For maximum protection all movable
openings should be protected in such a manner by the GRI Gate Mount Pool Alarm.
The GT10-2 and GT10-4 can be operated independently with an on-board 9 volt battery or with a 12 volt
externally supplied DC power source. Both power sources have been designed to maintain a maximum
sound pressure level of 85db at 10’. Estimated battery life is approximately 180 days based on no alarm
soundings during that time lapse. Should the battery voltage drop below 7 volts, a low battery mode
will be initiated and the unit will sound 3 beeps approximately every 30 minutes for one to two weeks
prior to total battery failure. Battery must be replaced at this time, and the cuase of the power failure
determined and restored.
NOTE: Unit will function at a minimum 5VDC at a very limited sounder volume. This power level is considered
total battery failure.
CLEANING: Periodic cleaning of sounder and box are required to maintain sound level.
CAUTION: To prevent a memory failure or circuit damage, external power source not to exceed 15VDC.
WARNING: Environmental conditions, such as wind, may aect the sound level.
WARNING: THIS IS NOT A LIFE SAVING DEVICE.
C_PA 5 Gate Mount Pool Alarm GT-10
Part Numbers
GT10-2 Gate Mount Pool Alarm - 7 Second Delay - Closed Loop
GT10-4 Gate Mount Pool Alarm - Instant On - Closed Loop

Made in U.S.A.
WARRANTY: One year limited warranty against workmanship, material and factory defects.
GEORGE RISK INDUSTRIES, INC.
G.R.I. PLAZA
KIMBALL, NE 69145
WWW.GRISK.COM
TOLL-FREE 1-800-445-5218
TOLL-FREE 1-800-523-1227
[phone]
FAX [phone]
E-MAIL: [email protected]
WWW.GRISK.COM
Gate Mount
Pool Access Alarm
INSTALLATION INSTRUCTIONS:
The GRI Gate Mount Pool Access Alarm mounts easily to the fence by any gate which allows access to the
pool/spa area. Using a Closed Loop magnetic reed switch, the unit will detect and announce an open
access by sounding a loud continuous alarm. Two timed options are oered: a maximum 7 second delay
mode prior to sounding upon gate opening, or an instant alarm sounding upon activation. Both versions
incorporate a built-in pass through feature shunt button to allow adult access without alarm sounding.
Although the Gate Mount Pool Access Alarm cannot be turned o, this feature will simply deactivate the
alarm function for a maximum of 15 seconds. During this time span the adult must exit and close the gate
before the alarm sounds. Once the alarm is sounding it cannot be silenced by simply closing the gate. The
shunt button must also be depressed.The sounder cannot be disabled by holding down the shunt button.
GT10 Gate Mount Pool Alarm Built to Scale
GEORGE RISK INDUSTRIES, INC.
KIMBALL, NE 69145
www.grisk.com
1-800-445-5218
E-MAIL: [e-mail]
1.56 in
5.31 in
3.38 in
5.41 in
Drain hole location
.40 in
1.10 in