HAMPTON BAY 28235 User manual

1-LIGHT EXTERIOR WALL LANTERN1-855-HD-HAMPTON
WWW.HAMPTONBAY.COM
THANK YOU
continually create
quality products designed to enhance your home. Visit us online to see our full line of products available for your home improvement needs. Thank you for choosing Hampton Bay! Questions, problems, missing parts? Before returning to the store, call Hampton Bay Customer Service8 a.m. – 7 p.m., EST, Monday – Friday, 9 a.m. – 6 p.m., EST, SaturdayItem#1007158019 1007259777 Model#28235 28236

Table of ContentsSafety InformationTable of Contents .......................................................2Safety Information .....................................................2Limited Warranty........................................................2What is Covered ....................................................2What is not Covered ..............................................2Pre-Installation .......................................................... 3Tools Required (not included) ...............................3Hardware Included ..............................................................3Package Contents ................................................................4Installation..............................................................................5Clear and Cleaning .................................................................6□Consult a qualified electrician if you have any electricalquestions.CAUTION: Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation. Please call our Customer Service Team at 1-855-HD-HAMPTON.WARNING: Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.2 Service Parts . ........................................................................ 6Troubleshooting.....................................................................6Contact the Customer Service Team at 1-855-HD-HAMPTON or visit WWW.HAMPTONBAY.COM. three (3) years from
date of purchase. This warranty applies only to the original consumer purch aser and only to products used in normal use and service. If this product is found to be defective, the manufacturer’s only obligation, and your exclusive remedy, is the repair or replacement of the product at the manufacturer's discretion,provide that product has been damaged through misuse,abuse,accdient,modeifications,alterations, neglect or mishandling. This warranty shall not apply to any product that is found to have been improperly installed, set up, or used in any way not in accordance with the instructions supplied with the product. This warranty shall not apply to a failure of the product as a result of an accident, misuse, abuse, negligence, alteration, or faulty installation, or any other failure not relating to faulty material or workmanship.This warranty shall not apply to the finish on any protion of the product,such as surface and/or weathering,as this is considered normal wear and tear.

3Pre-InstallationHARDWARE฀INCLUDED
NOTE: Hardware not shown to actual size.（ ）
PartDescriptionQuantityAAMounting bracket1BBMounting screw (Pre-assembled to mounting bracket (AA))2CCOutlet box screw2DDGreen ground screw (Pre-assembled to mounting bracket (AA))1PartDescriptionQuantityEEHex nut2FFWire connector3GGRubber washer2HHCap nut2AABBCCDDEE FFGGHHPhillips ScrewdriverSafety GogglesWireStripperElectricalTapePliersCaulkWWW.HAMPTONBAY.COM Please contact 1-855-HD-HAMPTON for further assistance.

Pre-Installation ฀PACKAGE฀CONTENTSAB4PartDescriptionQuantityAFixture body1BGlass piece4

5Installation 1Installing the mounting bracketWARNING: Turn off power at the circuit breaker and the light switch. Ensure the power is off before continuing.2Connecting the wiresUnscrew the two cap nuts (HH) and rubber washer(GG) from the mounting screws (BB). Remove the mounting bracket (AA)from the fixture body (A), and keep the cap nuts (HH) and rubber washer (GG) for later use. Loosen the hex nuts (EE) on the mounting screws (BB) and adjust the mounting screws (BB) so that they extend long enough to protrude the canopy of the fixture body (A), then secure the mounting screws (BB) in place using the hex nuts (EE).3
□
A
GG
HH
AA
EE
BB
□
AA CC
Fasten the mounting bracket (AA) onto the outlet box using two outlet box screws (CC).The side of the mounting bracket (AA) marked "GND" must face out. □
□Installing the light fixturePlace the fixture body (A) over the outlet box, and ensure the heads of the mounting screws (BB) come through the holes of the fixture body (A). Place the rubber washers (GG) over the mounting screws (BB), and tighten the cap nuts (HH) onto the mounting screws (BB) until the fixture body (A) is held firmly against the wall. Use weather resistant caulk (not included) to seal around the top and side perimeter of the back plate of the fixture body (A). Do not caulk the bottom of the back plate to allow for condensation evaporation.GG HH
FFWhite
Outlet box
BB
Base
BlackGround wireConnect the white wire from the light fixture to the white supply wire from the junction box using a connector (FF). Connect the black wire from the light fixture to the black supply wire from the junction box using a connector (FF). Connect the ground wire from the light fixture to the ground supply wire from the junction box using a connector (FF). Push the wires into the junction box. Mount the fixture body (A) onto the mounting bracket (AA) and secure with the mounting screws (BB).WWW.HAMPTONBAY.COM Please contact 1-855-HD-HAMPTON for further assistance.A
AAAInstall the light bulb (not included) in the socket of fixture body (A). Use one maximum 4W Type A medium base LED bulb or one maximum 60W Type A medium base regular filament Edison bulb .BB

6Care and Cleaning
□Do not use any cleaners with chemicals, solvents, or harsh abrasives. Use only a dry, soft cloth to dust or wipe carefully.□To clean the fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box. Use a dry or slightlydampened, clean cloth to wipe the exterior surface of the fixture.Troubleshooting
Problem Possible Cause Solution The bulb will not light. The bulb is burned out. Replace the bulb. The power is off. Ensure the power supply is turned on. The power cord is not plugged in. Ensure the power cord is plugged into the outlet. The circuit breaker is off. Ensure the circuit breaker is set to the "ON" position. The fuse blows, or the circuit breaker trips, when the light is turned on. There are crossed wires, or the power wire is grounding out. Discontinue use of the lamp. Check the wire connections. Contact a qualified electrician or call the Customer Care Service Team at 1-855-HD-HAMPTON. Service PartsMODEL TYPE : 28235 28236AABBCCDDEEFF GGHHPartDescriptionQuantityAAMounting bracket1BBMounting screw (Pre-assembled to mounting bracket (AA))2CCOutlet box screw2DDGreen ground screw (Pre-assembled to mounting bracket (AA))1PartDescriptionQuantityEEHex nut2FFWire connector3GGRubber washer2HHCap nut2

Questions, problems, missing parts? Before returning to the store, call Hampton Bay Customer Service8 a.m. – 7 p.m., EST, Monday – Friday, 9 a.m. – 6 p.m., EST, Saturday1-855-HD-HAMPTONWWW.HAMPTONBAY.COM Retain this manual for future use.