Hans Grohe AXOR One 280 1jet 48491 7 Series User manual

INSTALLATION
ZH ⁄ 用户手册 ⁄ 组装说明 02
EN ⁄ Instructions for use ⁄ assembly instructions 03
Lesezeichen
中文 02
English 03
AXOR One 280 1jet
48493XX7
AXOR One 280 1jet
48491XX7

02
墙壁安装 (参见第页 05)
ZH
安全技巧
装配时为避免挤压和切割受伤，必须戴上手套。
本产品只允许作为洗浴、卫生和洁身之用。
头顶花洒夹持杆只为夹持头顶花洒而设计，不得
让其承载其它物品！
不得让儿童和肢体、精神和⁄或意识有障碍的成人
在不受监管的情况下使用淋浴系统。受酒精或毒
品影响的人员不得使用淋浴系统。
必须避免让身体敏感部位 (如眼睛) 接触到莲蓬头
喷水。必须保持莲蓬头与人头之间有足够的距
离。
安装提示
⁄ 安装前必须检查产品是否受到运输损害。 安装后
将不认可运输损害或表面损伤。
⁄ 管道和阀门必须根据通用标准进行安装、冲洗和
检查。
⁄ 请遵守当地国家现行的安装规定。
⁄ 由有资格的专业人员进行产品安装时请注意：在
所有加固区域中，加固表面是否平整 (无突出的接
缝或瓷砖) ，墙体结构是否适合产品安装且未显露
出任何缺点。
技术参数
工作压强： 最大 1 MPa
推荐工作压强： 0,1 - 0,5 MPa
测试压强： 1,6 MPa
(1 MPa = 10 bar = 147 PSI)
热水温度： 最大 60°C
热力消毒: 70°C ⁄ 4 分钟
该产品专为饮用水设计！
符号说明
请勿使用含有乙酸的硅胶！
大小 (参见第页 04)
流量示意图 (参见第页 04)
备用零件 (参见第页 15)
XX = 颜色代码
00 = 镀铬
67 = Matt Black
选装附件 (参见第页 11 )
不在供货范围内
⁄ 加长件 90 mm
清洗 (参见第页 12)
该区域需要一个加固边壁。
(参见第页 06 ⁄ 09)
+
天花板安装 (参见第页 09)

03
WALL MOUNT (see page 05)
EN
SAFETY NOTES
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The arm of the shower head is intended only to hold
the shower head. Do not load it down with other
objects!
Children as well as adults with physical, mental and⁄or
sensoric impairments must not use this product without
proper supervision. Persons under the influence of
alcohol or drugs are prohibited from using this product.
Do not allow the streams of the shower touch sensitive
body parts (such as your eyes). An adequate distance
must be kept between the shower and you.
INSTALLATION INSTRUCTIONS
⁄ Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
⁄ The pipes and the fixture must be installed, flushed and
tested as per the applicable standards.
⁄ The plumbing codes applicable in the respective
countries must be observed.
⁄ During installation of the product by qualified trained
personnel, make sure that the entire fastening surface is
even and smooth (no protruding seams or tile offset),
that the finish of the wall is suitable to apply the product
and has no weak points.
TECHNICAL DATA
Operating pressure: max. 1 MPa
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure: 1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature: max. 60°C
Thermal disinfection: 70°C ⁄ 4 min
The product is exclusively designed for drinking water!
SYMBOL DESCRIPTION
Do not use silicone containing acetic acid!
DIMENSIONS (see page 04)
FLOW DIAGRAM (see page 04)
SPARE PARTS (see page 15)
XX = Colors
00 = Chrome Plated
67 = Matt Black
SPECIAL ACCESSORIES
(see page 11)
order as an extra
⁄ extension 90 mm
CLEANING (see page 12)
The wall must be reinforced in this area.
(see page 06 ⁄ 09)
+
CEILING MOUNT (see page 09)

04
131Ø
G1/2
5
°
5
°
24
30
390
106
Ø 282
Ø 131
25Ø
5
°
5
°
282Ø
21
147
30
29
G1/2
bar
4,5
0,0
0,5
1,0
1,5
2,0
2,5
3,0
3,5
4,0
5,0
0,45
0,00
0,05
0,10
0,15
0,20
0,25
0,30
0,35
0,40
0,50
5,50,55
6,00,60
036912151821242730
MPa
00,1 0,2 0,3 0,4 0,5
Q = l/min
Q = l/sec
Maße Durchflussdiagramm
AXOR One 280 1jet
48491XX7
AXOR One 280 1jet
48491XX7
AXOR One 280 1jet
48493XX7
AXOR One 280 1jet
48493XX7

05
max. 5 mm
+ 59 mmX
1
2 3
Durchflussdiagramm Montage 48491
AXOR One 280 1jet
48491XX7

06
1.
2.
60 mm
Ø 6 mm
SW 8 mm
1.
2.
59 mm
Silicone
1.
2.
Silicone
4 5
6 7
8 9
Verstärkung

07
SW 10 mm
Armaturenfett
Grease
䀵滑油
1.
2.
10 11
12 13
14 15
Montage

08
SW 27 mm
(4 Nm)
16 17
18
Montage

09
SW 8 mm
3.
4.
Silicone
max. 5 mm
+ 55 mmX
1
2 3
Montage 48493 Verstärkung 48493
AXOR One 280 1jet
48493XX7

10
Ø 6 mm
60 mm
1.
2.
55 mm
Silicone
4 5
6 7
8 9
Montage