Hearth & Home BRICK-MI30 User manual

1Hearth & Home Technologies • BRICK-MI25, BRICK-MI30, BRICK-MI35 Refractory Kit Instructions • 2532-936 Rev. C • 3/19
BRICK-MI25, BRICK-MI30, BRICK-MI35
Models: SUPREME-I25-IFT, SUPREME-I30-IFT, SUPREME-I35-IFT, RUBY25IN, RUBY25IL, RUBY30IN, RUBY30IL, RU-
BY35IN, RUBY35IL, EXCURSION-I, EXCURSION-II, EXCURSION-II, PROV-I30-IPI, PROV-I35-IPI JASPER30IN, I30X-AU
- Refractory Installation Instructions -
CAUTION! Risk of Cuts or Abrasions. Wear protective
gloves and safety glasses during installation.
NOTICE: Handle refractory panels with care. Refractory
may chip or crack if dropped or impacted.
KIT COMPONENTS (Refractory shown in Figure 1)
(1) Left Refractory
(1) Right Refractory
(1) Back Refractory
(1) Base Refractory
Leave this manual with party responsible for use
and operation.
Figure 3. Empty Firebox
Figure 1. Refractory Kit Components
INSTALLATION
PROV-I30-IPI, PROV-I35-IPI & JASPER30IN Only:
Discard base refractory. Base refractory not used with
these models.
1. Install base refractory. See Figure 4.
Figure 4. Base Refractory Installed
Figure 2. Cut Side Panels - PROV-I30-IPI & JASPER30IN Only
CUT CUT
PROV-I30-IPI, PROV-I35-IPI & JASPER30IN Only:
Cut the bottom leg off of the right and left refractory. See
Figure 2.
Service Parts:
If replacement panels are needed, the entire kit must be
ordered.
I30X-AU INSTALLATION INSTRUCTIONS,
SKIP TO PAGE 3.

Hearth & Home Technologies • BRICK-MI25, BRICK-MI30, BRICK-MI35 Refractory Kit Instructions • 2532-936 Rev. C • 3/19
2
Figure 5. Back Refractory Installed
Figure 6. Left Refractory Installed
Figure 7. Left Refractory Handbend Tab
Figure 8. Right Refractory Handbend Tab
Figure 9. Refractory Kit Installed
3. Install left and right refractory, bend down tabs to hold
in place. See Figures 6, 7 & 8.
2. Install back refractory. See Figure 5.
Be sure to hold back refractory in upright position until
side panels get installed.

3Hearth & Home Technologies • BRICK-MI25, BRICK-MI30, BRICK-MI35 Refractory Kit Instructions • 2532-936 Rev. C • 3/19
CAUTION! Risk of Cuts or Abrasions. Wear protective
gloves and safety glasses during installation.
NOTICE: Handle refractory panels with care. Refractory
may chip or crack if dropped or impacted.
KIT COMPONENTS (Refractory shown in Figure 1)
(1) Left Refractory
(1) Right Refractory
(1) Back Refractory
(1) Base Refractory
Figure 2. Empty Firebox
Figure 1. Refractory Kit Components
1. Install base refractory. See Figure 4.
Figure 3. Base Refractory Installed
Service Parts:
If replacement panels are needed, the entire kit must be
ordered.
I30X-AU INSTALLATION INSTRUCTIONS:
Figure 4. Back Refractory
2. Install back refractory.
 Topofrefractorymustgo inbehindbafecover rst,
then swing bottom in place. See Figures 4 and 5.
Be sure to hold back refractory in upright position until
side panels get installed.
Figure 5. Back Refractory Installed

Hearth & Home Technologies • BRICK-MI25, BRICK-MI30, BRICK-MI35 Refractory Kit Instructions • 2532-936 Rev. C • 3/19
4
Please contact your Hearth & Home Technologies dealer with any
questions or concerns.
For the location of your nearest Hearth & Home Technologies dealer,
please visit www.hearthnhome.com.
Hearth & Home Technologies
7571 215th Street West, Lakeville, MN 55044
www.hearthnhome.com
Figure 6.
Figure 7. Left Refractory Installed
Figure 8. Refractory Kit Installed
3. Slide left and right refractory in between bafe cover
andslideofrebox..SeeFigures6,7&8.
BAFFLE COVER
FIREBOX