Herman Miller Embody User manual

HermanMiller Embody®Chair Adjustment Guide1
Seating that
performs for you.
HermanMiller
Embody®Chair
Seat Depth: Front handles on the right and le sides of the seat
Seat Height: Joystick inside tilt tension knob, right side of chair
To increase or decrease depth:
Li your thigh weight from the front
of the seat. Gently li up the front
handles on the right and le sides of
the seat to disengage the locking seat
depth adjustment. Slide seat forward
or back into proper depth for use; then
release downward to lock the seat.
In the proper position, you will have approximately three-ngers of clearance
between the back of your knees and the seat edge.
Only available on some models.
To raise seat:
Angle the joystick fully and li your
weight to raise the seat height to the
desired level.
To lower seat:
While seated, angle the joystick fully
and lower seat.
At the proper height, your feet should rest flat on the floor.
Tilt Limiter: Back horizontal tab on le side behind seat
Tilt Tension: Knob below right side of seat
Only available on some models.
To engage:
Recline and move tab up to dene
the limit of recline.
To release:
Lean forward and flip tab fully
downward.
Engage the tilt limiter when you want to sit in an upright or partially
reclined position.
To increase tension:
Turn knob clockwise.
To decrease tension:
Turn knob counterclockwise.
Set the tilt tension to control the resistance you feel when leaning back.

Adjustment Guide2HermanMiller Embody®Chair
Arm Width:
Arm Height: Button underneath each arm
To raise arms:
Grasp arms while pressing button on
the underside of each armpad and pull
up to desired position. Release button
to lock.
To lower arms:
Grasp arms while pressing button on
the underside of each armpad and
lower to desired position. Release
button to lock.
For maximum comfort, your arms should make contact with the arm pad
without any lift at your shoulders.
To adjust arm width:
Place two hands on one armpad to
pull in or push out. Repeat with other
armpad.
In the proper position, your elbows should be in line with your shoulders.
BackFit™Adjustment: Knob on right side behind seat.
Only available on some models.
For a flat back, rotate forward:
Turn the BackFit adjustment knob
clockwise to the full forward position
or move it slightly back by turning knob
counterclockwise.
For a curved back, rotate backward:
Turn the BackFit adjustment knob
counterclockwise to rotate the back
rearward.
Adjust the BackFit to position the back of the chair to t the curvature of your
entire back, placing your head in a balanced position for alignment with your
computer display.