Herman Miller Canvas Office Landscape User manual

Z
© 2017 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
TM Y, L, Canvas Office Landscape are among the trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b67pc rev C.
1
YCanvas Office Landscape™Top Cap Installation and
Disassembly for Recycling Instructions
Parts Included:
Tools Required:
Top Cap
Alignment Shim (1)
A
D
Hardware Pack
Safety Glasses

Z
© 2017 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
TM Y, L, Canvas Office Landscape are among the trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b67pc rev C.
2
1. Space Top Cap Brackets Evenly on Top Cap.
Top Cap Brackets
2. Install Cladding onto frame.
3. Align ends of Top Cap(A)
with sides of frame. Do not
press down over Wire
Channels.
4. Legs of top cap brackets
must be centered on wire
channels in order to work
properly.
A
Cladding
Top Cap
Bracket Legs
Centered
Assembly Instructions:

Z
© 2017 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
TM Y, L, Canvas Office Landscape are among the trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b67pc rev C.
3
Alignment Shim
A
5. When installing adjacent Top Cap(A), insert Alignment Shim(D) half way
into rst Top Cap. Align the bridge of the Alignment Shim(D) with the gap
between the two wire channels.
A
6. Insert adjoining Top Cap(A) over the Alignment Shim(D).
7. Press Top Cap(S) down over Wire Channels with no gap between Top Caps.
Gap Between
Wire Channels
Bridge of Shim

Z
© 2017 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
TM Y, L, Canvas Office Landscape are among the trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b67pc rev C.
4
Disassembly for Recycling:
Materials Identication and Segregation:
Where possible, plastic components are marked with ASTM recycling codes.
Use these codes to identify material type for recycling. Non marked components
should be treated as mixed plastic. Ferrous metals can be identied using a
small magnet for recycling. Non-ferrous metals should be separated and recycled
separately.
To disassemble product, reverse steps 6 through 1.