Herman Miller Canvas Vista Credenza Installation instructions

Power Driver
Tools Required
Parts Included
HermanMiller
Canvas Vista Credenza Installation and
Disassembly for Recycling Instructions
How to assemble Canvas Vista Credenza Tip Out Stud Storage Leg
. Once cabinet is leveled and in place, adjust the hinges on the tip
out bins to create consistent gaps and alignment of the drawer fronts.
Step 
#2 Phillips
Bit
Allen wrench
(1/8”)
. Set driver on low torque setting to ensure that the screws do not
strip the wood during installation.
. Place the legs in the corner and align with pilot holes, drive ()
screws to fasten the legs to storage’s bottom panel.
Step 
L2CFL2CFS
1HermanMiller Installation Instructions1BNR09 rev A

2HermanMiller Installation Instructions1BNR09 rev A
. Take Tip Out stud and insert it into the LEFT circle cutout in the tip
out bin or tray.
Note: The stud must be behind the stop tab.
. Once inserted, use an allen wrench to Apply an axial force
while tightening the screw so that the rubber well nut compresses
on the opposing side. Tighten the screw until snug, but do not
over tighten.
Axial force
View from back side of the tip out stud
Step 
Step 
For more information about our products and services please visit us at
hermanmiller.com or call ()  .
© Herman Miller, Inc., Zeeland, Michigan Printed in U.S.A. Part No. BNR  A
. Once the drawer fronts are adjusted properly, tip back tip out bin
so that circular cutout is just inside the tab in side of cabinet (roughly
 degrees).
Step 