Herman Miller Sayl User manual

HermanMiller SAYL®Chair Adjustment Guide1
Seating that
performs for you.
HermanMiller
SAYL®Chair
Seat Depth: Lever under le side of seat
Seat Height: Lever next to tilt tension knob, right side of chair
To raise seat:
Take your weight o chair, li tab up.
To lower seat:
While seated, li tab up.
At the proper height, your feet should rest flat on the floor.
To increase depth:
Pull lever out, slide thighs forward to
adjust seat; release lever.
To decrease depth:
Pull lever out, push seat back and
release lever.
In the proper position, you will have approximately three-ngers of clearance
between the back of your knees and the seat edge.
Only available on some models.
Forward Tilt: Front horizontal tab on le side of seat
Tilt Tension: Knob below right side of seat
To increase tension:
Turn knob clockwise.
To decrease tension:
Turn knob counterclockwise.
Set the tilt tension to control the resistance you feel when leaning back.
To position chair forward:
Recline and flip lever down.
To resume horizontal position:
Recline and flip lever up.
Engage forward tilt to support the thighs’ declined posture when
performing intensive tasks such as keyboarding.
Only available on some models.

Adjustment Guide2HermanMiller SAYL®Chair
Lumbar Height: Back lever or pad, depending on work chair, behind Y-Tower.
Tilt Limiter: Back horizontal tab on le side of seat
To engage:
Recline and move tab up to dene
the limit of recline.
To release:
Lean forward and flip tab fully
downward.
Engage the tilt limiter when you want to sit in an upright or partially
reclined position.
Only available on some models.
To raise or lower:
Move back lever or pad behind Y-Tower
up or down as needed.
Adjust the lumbar height so that it comfortably supports the natural curve
of your spine.
In upholstered chairs the lumbar lever is located behind the Y-Tower.
Arm Height:
Only available on some models.
To raise arms:
Grasp the arms and pull up gradually to
desired height.
To lower arms:
Grasp arms and pull up to highest
position, release, push down to lowest
position and then raise to desired
height.
For maximum comfort, your arms should make contact with the armpad
without any lift at your shoulders.
Arm Width:
Only available on some models.
To adjust arm width:
Grasp armpad to pull in or push out.
In the proper position, your arms should be in line with your shoulders.
Arm Angle:
Arm Depth:
Only available on some models.
Only available on some models.
To pivot arms in or out:
Grasp armpad and pivot to the
le or right.
Adjust arm angle inward when using a keyboard; adjust arm angle
outward when using a mouse.
To adjust arm depth:
Grasp armpad and slide forward or
backward.
Adjust for comfort. Avoid any pressure on wrists and elbows.