Herman Miller Nelson User manual

How to assemble
your table.
HermanMiller
The Collection
NelsonTM Table Installation Instructions
For more information about our products and services or to see a list of dealers, please visit us at
hermanmiller.com or call [phone].
© 2017 Herman Miller, Inc., Zeeland, Michigan Printed in U.S.A. Part No. 1b2wcy - E.
TM Y, Nelson are among the trademarks of Herman Miller, Inc.
Round - Top Surface Rectangular - Top Surface
Leg (qty:4)
Leg (qty:2) Stretcher
Stretcher (qty:2) Joint Connector (qty:8)
Joint Connector (qty:4)
1/4-20 Screw (qty:32)
1/4-20 Screw (qty:32)
M5 Allen Wrench 3/16” Allen Wrench
Parts Included
For Rectungalur Table:
For Round Table:
Tools Required
Step 2
1.1
Lay table face down on padded clean surface.
Step 1
2.1
Remove blue plastic netting on legs, prior to affixing table base to leg. (Screw holes will
not match up unless this is done first.)
2.2
Assemble stretcher(s) to legs. Tighten joint connectors (male and female) using two allen
wrenchs.
(For round surface)
HermanMiller Eames®Table Assembly Instructions1

HermanMiller Eames®Table Assembly Instructions2
Step 2
3.1
Align holes in legs with holes in table top as shown (alternating screw assembly).
Step 3
Step 3
(For round surface)(For rectangular surface)
(For rectangular surface)
2.1
Assemble stretcher(s) to legs. Tighten joint connectors (male and female) using two allen
wrenchs.
3.1
Align holes in legs with holes in table top.

HermanMiller Eames®Table Assembly Instructions3
4.1
Tighten 1/4-20 screws using 3/16 allen wrench.
5.1
When assembling home desk use packaging filler to support the front edge of the desk to
prevent damage.
Step 4
Step 5
(For rectangular surface)
6.1
Rotate table back to upright position.
Step 6
4.1
Tighten 1/4-20 screws using 3/16 allen wrench.
Step 4 (For round surface)