Herman Miller Setu Table User manual

Z
© 2013 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, Action Office, and Mirra 2 are among the registered trademarks of Herman MIller, Inc.
TM Sense, Setu, Be Collection and Sayl are among the trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b9rtx rev C.
1
YSetu™Table Installation
Parts Included:
Table Top
A
Tools Required:
Power Driver 7/8” Hex Socket Torque Wrench
#2 Phillips Bit
Hardware Pack
Pan Head Tapping
Screw (4)
Spider
Column Draw Rod
Anti-Rotation Cap Lock Washer
F
C
DE
G H
Base Assembly
B

Z
© 2013 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, Action Office, and Mirra 2 are among the registered trademarks of Herman MIller, Inc.
TM Sense, Setu, Be Collection and Sayl are among the trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b9rtx rev C.
2
1. Align Mounting holes in Spider(C) with
holes in Table Top(A).
2. Install 4 Pan Head Tapping Screws(F).
Notice: If Spider comes mounted to 2 boards, remove Screws and Boards.
Dispose of properly. Do not use these screws to mount Spider to Table Top!
3. Lock Washer(H) and
Anti-rotation Cap(G) from
Draw Rod(E).
A
E
HG
F
C
Mounting Hole
Hole
Board
Board
Screw
Screw
Screw
Screw
Spider

Z
© 2013 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, Action Office, and Mirra 2 are among the registered trademarks of Herman MIller, Inc.
TM Sense, Setu, Be Collection and Sayl are among the trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b9rtx rev C.
3
6. Align Anti-rotation Cap(G) with
Notches in Base. Place into position
on Base.
Slot
Notch
Notch
5. Place Base(B) onto Column while
aligning Slots in Column with
Notches in Base.
BG
4. Position Column(D) onto Spider
while aligning slot in Column with
Tab on Spider.
D
H
Slot
Tab

Z
© 2013 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, Action Office, and Mirra 2 are among the registered trademarks of Herman MIller, Inc.
TM Sense, Setu, Be Collection and Sayl are among the trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b9rtx rev C.
4
7. Tighten Draw Rod to 450-550 in lbs
(50-62 Nm).
H
G