Hitron CGN User manual

Weave Cable Modem Setup Guide
Revised: 2019-07-31
These instructions detail how to install a Hitron CGN cable modem and router with Weave's
network. Please contact Weave Support at any point in time, if the instructions do not make
sense or you are not getting the same results as the pictures.
Please note, you may have received your modem but your internet will not work until Weave
Networks has correctly connected you to the network. Please make sure you have received an
email or a call from a Weave staff member saying your internet is now connected before
attempting the below.
Step 1
Unbox the Hitron CGN modem (or if you have your own modem). It should look like the picture
above.
Step 2
Take the coax cable, it should look like the
cable pictured.
www.weavenetworks.com 1-587-415-2900 [e-mail] Page 1 / 4

Weave Cable Modem Setup Guide
Revised: 2019-07-31
Step 3
Plug one end of the coax cable into the wall socket.
Make sure to screw the cable in tight. You will find these
normally in your living room or bedrooms where a TV can
be connected.
Step 4
Plug the other end of the coax cable into the back
of the modem. Make sure to screw the cable in tight.
www.weavenetworks.com 1-587-415-2900 [email protected] Page 2 / 4

Weave Cable Modem Setup Guide
Revised: 2019-07-31
Step 5
Power on the modem. You can achieve this
by connecting the power into the modem
and then connect it to a wall power socket.
Step 6
Wait up to 5 minutes, then the lights on the modem should now show the following:
Power
Solid Green
Uplink (Up arrow house)
Solid Green or Blue
Downlink (Down arrow house)
Solid Green or Blue
Internet (@)
Solid Green
LAN (Computer symbol)
Black (Not on)
USB
Black (Not on)
WPS
Black (Not on)
Wireless
Solid Green or Blinking
www.weavenetworks.com 1-587-415-2900 [email protected] Page 3 / 4

Weave Cable Modem Setup Guide
Revised: 2019-07-31
Step 7
You should now able to connect your computer to
one of the yellow ports on the back of your
modem and have internet access to your
computer.
Step 8
You have now successfully set up your internet.
You should now be able to connect to the wireless using a phone or laptop and get internet
access. The WIFI username and password is on the back of the router. Please call Weave
Support if you can't.
www.weavenetworks.com 1-587-415-2900 [email protected] Page 4 / 4