HOMCOM 824-007 User manual

TOWER FAN
824-007(TF3803TR-L) 824-006(TF4604TR-L)
220-240V~50-60Hz 45W
EN C000000

READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL,
OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF
AND.OTHER BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO
COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY
AND/OR PROPERTY DAMAGE!
IMPORTANT SAFETY INFORMATION
1. Read all instructions carefully before using the FAN.
2. Use this FAN only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electrical
shock, or injury to persons.
3. Remove the package and ensure that the FAN is undamaged. In
case of doubt do not use FAN and contact with your supplier.
4. Don not let children play parts of package.
5. Before use the FAN, check if the voltage marked on the rating
label corresponds to the mains in your home.
6. Extreme caution is necessary when the FAN is used by or near
children or Invalids and whenever the FAN is left operating
unattended.
7. Avoid using extension cord as the extension cord may overheat
and cause a risk of fire.
8. Do not pull the power cord to disconnect with power source.
Always grasp the plug to pull out.
9. Do not insert any objects into the FAN as it may cause an electric
shock or injure or damage to the FAN. Do not block or tamper
with the FAN in any manner while it is in operation.
10. Do not leave the FAN unattended. Always unplug FAN when not
in use.
11. This FAN is not intended for use in wet or damp locations. Never
locate a FAN where it may fall into a bathtub or other water
container.
12. Do not use FAN outdoors.
13. Disconnect the fan from the mains power when not in use, and
before servicing or performing any maintenance.

14.Always disconnect the fan from the power supply when
moving it from one location to another.
15.Keep the fan clean and maintain in good condition (use
an authorized service agent).
16.Use recommended parts only (non genuine parts may
be dangerous, and will invalidate your warranty).
17.When not in use store in a safe, dry, childproof location.
18.This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe
way and understand the hazards involved. Children
shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without
supervision.
WARNING :
To avoid danger of electric shock, unplug
from outlet when not in use and before
cleaning. If the supply cord is damaged, it
must be replaced by the manufactory or
it’s service agent or a similarity qualified
person in order to avoid a hazard.
WARNING :
The Main Power Switch and the On/Off
switch should not be used as the sole
means of disconnecting power. Always
unplug the power cord before servicing
or moving the unit.

PARTS NAME
TF3803TR-L TF4604TR-L
ASSEMBLY
The base of the tower fan comes in two parts, which fit around the oscillation
base. Both parts fit easily together.
1.First attach the front half of the base, aligning the holes in base with the
screw hole in the oscillation base, and leading the power cord up the base.
2.Then snap the back half of the base to the front half and secure with the
plastic screw nut (supplied),wise it clockwise
(Figure1)

(Figure 1)
3. Thread the power supply cord through the two cut-outs at the bottom of the
base.
REMOTE CONTROL
1. Install one ‘mercury’ ( included) batteries.
2. The Remote Control Power button is labeled as such. All the functions
performed with the Remote Control work identically to the Manual Controls.
( FIGURE 2).

(FIGURE 2)
OPERATION
The FAN may be operated by the manual controls located on the FAN (as
shown in FIGURE 3) or by your remote control (shown in FIGURE 2) .
(FIGURE 3)
1. Place the FAN on a stable flat surface. Plug the cord set into a
220-240V~A.C. electrical outlet. Plug on the FAN, existing room
temperature will be displayed at display panel.

2. POWER : Turn the FAN on by pressing the ‘POWER’ button;
Turn the FAN off by pressing the ‘POWER’ button again.
3. SPEED :You can adjust the fan speed to the desired level:
low, medium, or high by pressing ’SPEED’ . The speed setting is
displayed on the LED panel (shown in FIGURE 4) ...
4. MODE : Pressing the ’ MODE’ button will set the FAN into
NORMAL mode, NATURAL mode , SLEEP mode and Child
mode
- NORMAL Mode : fan will start work at any speed you set
up.
- NATURAL Mode :fan will start work at high speed(15s),
middle speed(15s) and low speed(15s), it works as per this recycle.
- SLEEP Mode : if you set the mode at high speed, fan will
work at high speed at 30 mins, then transfer to middle speed at 30
mins and transfer to low speed until fan stop working.
- Child Mode : Fan will auto. Set up timer at 3 hours,
oscillation function will start, Ionizer function will start(if has). And it
will work at high speed at 15 minutes, transfer to middle speed at 15
minutes, then transfer to low speed until it take off. You can take off
oscillation function by manual.
5. TIMER : The fan is equipped with a timer that allows you to

set its length of operation from 1 hour to 12 hours.
6. OSCILLATION : Pressing the ‘OSC’ button will start and
stop the oscillation function. The symbol is displayed on the LED
panel.
TF3803TR-L TF4604TR-L
7. Cable Hock: The cable hock is packed with user manual, take it
out and install at the back side of product.Hanging the power cord
at cable hock when the fan is not be used.(FIGURE 5)
(FIGURE 5)
MAINTENANCE
1. This can only be done by an authorized service agent such as your local
FIGURE 4

Sealer dealer or any agent qualified to undertake electrical repairs.
3. If the unit requires external cleaning make sure it is switched off and
unplugged from the mains supply. Use a soft tissue or cloth for general
cleaning. To remove more persistent dirt or grime wipe down with a
cloth that has been dampened with warm soapy water. Do not use any
solvents ( such as thinners ) as these may damage the plastic casing.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the
appliance.
CONFORMITY WITH DIRECTIVES
This product is CE marked to denote conformity with Directives 2006/95/EC
(Low Voltage) and the EMC directive (2004/108/EC), as amended.
Correct Disposal of this product
This marking indicates that this product should not be
disposed with other household wastes throughout the EU.
To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the
return and collection systems or contact the retailer where
the product was purchased. They can take this product for
environmental safe recycling.