Home Styles 88 5053 30 User manual

Home Styles Consumer Assistance : www.homestyles-furniture.com,
[email protected], 888-680-7460, 877-831-0319
Hardware List
Part List
Tools required for assembly : Phillips screwdriver, Level
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damage occurring to the parts.
We have taken great care in the design of this
product and request that you carefully and strictly
follow our assembly instructions to ensure
a completed product as it was designed.
IMPORTANT NOTE
88 5053 30
Table
A.
Top
1 pc.
B.
Shelf
1 pc.
D.
Stretcher
2 pcs.
E.
Stretcher
2 pcs.
Hex Wrench
1 pc.
Small Hex Wrench
1 pc.
Spring Washer
24 pcs. (+1 extra)
Flat Washer
24 pcs. (+1 extra)
M6x16
Head Cap Bolt
24 pcs. (+1 extra)
M4x38
Wood Screw
4 pcs. (+1 extra)
C.
Base
1 pc.
Adjustable Pin
4 pcs. (+1 extra)
F.
Side Frame
2 pcs.

Assembly Instructions 2/3
IMPORTANT
* Please keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future.
* Do not tighten all the Head Cap Bolts until each part is properly assembled.
* Use a soft cloth between these parts and the floor.
* Please make sure unit is level before tightening these screws.
* After assembly, item must be level to work properly. Use the included adjustable levelers to level.
D
E
E
D
F
F
STEP 1
Attach Stretchers (D) and (E) to
Side Frame (F) with Flat Washers,
Spring Washers and Head Cap Bolts,
tightening the bolts only half way.
(See Figure 1)
Attach Side Frame (F) to unit
with Flat Washers,
Spring Washers and
Head Cap Bolts, tightening the
bolts only half way.
Figure 1
Head Cap Bolt
Spring Washer
Flat Washer
STEP 2
Place Top (A) upside down on a soft cloth.
Attach unit to Top (A) with Flat Washers,
Spring Washers and Head Cap Bolts,
tightening the bolts only half way.
Tighten all Head Cap Bolts.
A
Head Cap Bolt
Spring Washer
Flat Washer

Assembly Instructions 3/3
Figure 3
Figure 2
STEP 3
Attach Shelf (C) to unit with Wood Screws.
(See Figure 2)
C
Wood Screw
B
STEP 4
Turn the unit over to its’ upright position.
Insert Adjustable Pins into unit at the desired level.
Place Shelf (B) into position.
To level the unit, adjust the adjustable levelers on the bottom of unit.
(See Figure 3)
Adjustable Pin