Home Styles Modern Craftsman Media Console 88 5050 06 User manual

Hardware List
D.
Side Frame
2 pcs.
B.
Stretcher
4 pcs.
C.
Stretcher
1 pc.
IMPORTANT NOTE
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damages occuring to the parts.
We have taken great care in the design of this
product and request that you carefully and strictly
follow our assembly instructions to ensure a
completed product as it was designed.
A.
Cabinet
1 pc.
88 5050 06
Modern Craftsman
Media Console
Home Styles Consumer Assistance Line 888-680-7460 and 877-831-0319
[email protected]
Part List
E.
Shelf
2 pcs.
Head Cap Bolt
24 pcs. (+1 extra)
Hex Wrench
1 pc.
Small
Hex Wrench
1 pc.
Wood Screw
27 pcs.(+1 extra)
Flat Washer
24 pcs. (+1 extra )
Spring Washer
24 pcs. (+1 extra )
Tools required for assembly : Phillips screwdriver Tools recommended for assembly : Level

Assembly Instructions 2/4
STEP 1
Slide Shelf (E) into the middle of unit.
Attach Stretchers (B) and (C) to
Side Frame (D) with Head Cap Bolts,
Spring Washers and Flat Washers.
Tighten Head Cap Bolts only halfway. (See figure 1)
Attach the other Side Frame (D) to unit with
Head Cap Bolts, Spring Washers and Flat Washers.
Tighten all Head Cap Bolts.
STEP 2
Flat Washer
Spring Washer
Head Cap Bolt
Figure 1
IMPORTANT
* Do not tighten up all the screws until each part is properly assembled.
* You should keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future.
* Use a soft cloth between these parts and the floor.
* After assembly, item must be level to work properly. Use the included adjustable levelers to level.
B
B
B
B
C
Attach with Head Cap Bolts, Spring Washers
and Flat Washers into the pre-drilled holes.
Attach with 7X Wood Screws.
D
D
E
Wood Screw

Assembly Instructions 3/4
STEP 4
A
Attach unit onto Cabinet (A)
with Head Cap Bolts,
Spring Washers
and Flat Washers.
Attach with 10X Wood Screws.
Remove the drawers,
then place Cabinet (A)
upside down on a soft cloth.
A
STEP 5
STEP 3
Wood Screw
Slide Shelf (E)
into position.
Attach with
Head Cap Bolts,
Spring Washers
and Flat Washers
into the pre-drilled holes.
Attach with 10X Wood Screws.
A
E

Assembly Instructions 4/4
Turn the unit over to its’ upright position.
Slide the drawers into position.
Figure 2
To level the unit, adjust the adjustable
levelers on the bottom of unit. (See figure 2)
STEP 6
STEP 7
Remove the Pull Handles that are installed on the inside of the
drawers and re-install them on the outside of the drawer.