Home Styles 88 5123 89C User manual

PART LIST
HARDWARE LIST
E.
Front Stretcher
1 pc.
88 5123 89C
Bar Stool Set with
Decorative Stainless Steel Accents
(Set includes two Bar stools and one High Table)
C.
Leg
1 pc.
D.
Leg
1 pc.
F.
Side Stretcher
1 pc.
G.
Side Stretcher
1 pc.
B.
Back Frame
.1 pc
A.
Seat
1 pc.
Hex Wrench
1 pc.
Tools Required For Assembly : Phillips screwdriver
Home Styles Consumer Assistance Line 888-680-7460 and 877-831-0319
[email protected]
Head Cap Bolt
(long)
4 pcs.(+1 extra)
Wood Screw
6 pcs.(+1 extra)
Head Cap Bolt
(middle)
4 pcs. (+1 extra)
Spring
Washer
11 pcs.(+1 extra)
Flat
Washer
11 pcs.(+1 extra)
Head Cap Bolt
(short)
3 pcs. (+1 extra)
Small
Hex Wrench
1 pc.
IMPORTANT NOTE
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damages occuring to the parts.
We have taken great care in the design of this
product and request that you carefully and strictly
follow our assembly instructions to ensure a
completed product as it was designed.

Assembly Instructions
STEP 2
Attach the Leg (C) to Seat (A) with Head Cap Bolts (middle),
Spring Washers and Flat Washers.(See figure 1)
Attach the Front Stretcher (E) to the Leg (C).
Attach the Leg (D) to the Assembled Unit with
Head Cap Bolts (middle), Spring Washers and
Flat Washers, then tighten Head Cap Bolts half way.
Insert the Wood Screws from the Front Stretcher (E)
to the Legs (C) and (D) as shown and tighten them.
(See figure 2)
STEP 1
Attach the Back Rail of
Back Frame (B) to the unit
with Head Cap Bolts (short),
Spring Washers and
Flat Washers. (See figure 3)
Tighten Head Cap Bolts half way.
For the corner,
use Head Cap Bolts (long),
Spring Washers and
Flat Washers. (See figure 4)
Tighten Head Cap Bolts half way.
Attach the Side Stretcher (F) to
the unit and Front Leg (C) with
Wood Screws.
Attach the Side Stretcher (G) to
the unit and Front Leg (D) with
Wood Screws.
Tighten up all the Head Cap Bolts
and Wood Screws.
A
E
D
C
B
G
F
Flat Washer
Flat Washer
Flat Washer
Spring Washer
Spring Washer
Spring Washer
Head Cap Bolt
(middle)
Head Cap Bolt
(long)
Head Cap Bolt (short)
(Figure 1) (Figure 2)
(Figure 3) (Figure 4)
C
D
Wood Screw
Wood Screw
Head Cap Bolt
(middle)
Spring Washer
Flat Washer
Head Cap Bolt
(short)
Spring Washer
Flat Washer
IMPORTANT
* Do not tighten up all the bolts until each part is properly assembled.
* You should keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future.
* Use a soft cloth between these parts and the floor.