Home Styles 88 5522 9413 User manual

Part List
88 5522 9413
Kitchen Island
IMPORTANT NOTE
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damages occuring to the parts.
We have taken great care in the design of this
product and request that you carefully and strictly
follow our assembly instructions to ensure a
completed product as it was designed.
Hardware List
Cam Lock
18 pcs.(+4 extra)
Cam Lock Screw
18 pcs.(+2 extra)
M4x22
Machine Screw
3 pcs.
Adjustable Pin
12 pcs. (+1 extra)
M3x19
Flat Head Screw
9 pcs. (+1 extra)
Tools required for assembly : Phillips screwdriver
Pull Handle
1 pc.
Also need the part(s) from carton 88 5522 9412, 88 5522 9411 or 88 5522 9421
Tools recommended for assembly :Level
PATENE 8,584,600 B2
M3x15
Wood Screw
for Magnet
2 pcs.(+1 extra)
Magnet
1 pc.
M3x15
Wood Screw (short)
for Drawer Base Part
and Back Panel
18 pcs. (+1 extra)
M3x25
Wood Screw (long)
for Drawer Side Part
8 pcs. (+1 extra)
Home Styles Consumer Assistance: www.homestyles-furniture.com,
[email protected], 888-680-7460, 877-831-0319
N.
Drawer
1 pc.
(Please refer to the last page(s) of
instructions for steps to complete drawer assembly)
D.
Middle Panel
1 pc.
E.
Back Stretcher
1 pc.
F.
Back Panel
2 pcs.
G.
Upright
1 pc.
H.
Front Rail
1 pc.
L.
Shelf
3 pcs.
M.
Door
1 pc.
I.
Base
1 pc.
Pull Handle
1 pc.

Assembly Instructions 6/6
Part List
N1.
Front Part
1 pc.
N5.
Base Part
1 pc.
N2.
Back Part
1 pc.
N3.
Side Part
1 pc.
N4.
Side Part
1 pc.
Figure 1
Figure 2
MAKE SURE ROLLER
IS ON THE BACK
N2
N2
N2
N3
N3
N3
N4
N4
N4
N5
N5
N1
N1
N1
Drawer (N)
Attach N1 to N3 and N4, using
a screwdriver andPhillips
wood screws (4X),long
tighten halfway.
Attach N2 to N3 and N4 using
wood screws (4X),long
tighten halfway. (See Figure 1)
Insert wood screws (6X)short
into the pre-drilled holes in N5,
tighten screws. (See Figure 3)
Slide N5 into the grooves in N3
and N4. Be sure to push N5 all
the way forward so it meets N1.
(See Figure 2)
STEP 1
STEP 2
STEP 3 Tighten all screws used in
drawer assembly.
Figure 3
Figure 4
Attach hardware pulls
with machine screws.
(See Figure 4)
STEP 4