Home Styles 88 5701 53 User manual

88 5701 53
Swivel Chair
Home Styles Consumer Assistance : www.homestyles-furniture.com,
[email protected], 888-680-7460, 877-831-0319
Hardware List
Part List
IMPORTANT NOTE
This product is made of sturdy, high quality aluminum
and will provide years of enjoyment. Do not use power tools
to assemble and only tighten bolts until they are snug.
Over tightening can cause damage to the aluminum.
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damages occurring to the parts.
We have taken great care in the design of this product and
request that you carefully and strictly follow our assembly
instructions to ensure a completed product as it was designed.
Key Wrench
1 pc.
Hex Wrench
1 pc. Flat Washer
4 pcs. (+1 extra)
M8x35
Bolt
4 pcs. (+1 extra)
Spring Washer (large)
4 pcs. (+1 extra)
Nut (large)
4 pcs. (+1 extra)
Flat Washer
8 pcs. (+1 extra)
M6x30
Head Cap Bolt
8 pcs. (+1 extra)
A.
Seat
1 pc.
B.
Back
1 pc.
C.
Frame
1 pc.
D.
Frame
1 pc.
E.
Cushion
1 pc.
F.
Cushion
1 pc.
G.
Connector
1 pc.
H.
Base
1 pc.
Spring Washer
8 pcs. (+1 extra)

Assembly Instructions 2/3
IMPORTANT
* Please keep Key Wrench and Hex Wrench in a safe place as you may need to tighten up the Nuts in the future.
* Use a soft cloth between these parts and the floor.
* Do not use power tools to assemble and do not over tighten the bolts and nuts.
* Do not tighten all the bolts and nuts until each part is properly assembled.
Figure 1
STEP 1
Attach Seat (A) and Back (B) to Frame (C) with
Flat Washers, Spring Washers and Head Cap Bolts,
tightening the bolts only half way. (See Figure 1)
STEP 2
Attach Frame (D) to unit with
Flat Washers, Spring Washers
and Head Cap Bolts, tightening
the bolts only half way.
Tighten all Head Cap Bolts
used in Steps 1 and 2.
STEP 3
Attach Connector (G) to unit with Bolts, Flat Washers, Spring Washers (large) and Nuts.
(See Figure 2)
G
Bolt
Flat Washer
Flat Washer
Spring Washer (large)
Nut
Figure 2
AB
C
Flat Washer
Head Cap Bolt
Spring Washer
Flat Washer
Head Cap Bolt
D
Spring Washer

Assembly Instructions 3/3
H
STEP 4
Place unit onto Base (H).
STEP 5
Place Cushion (E)
and then Cushion (F) onto unit.
Use the tie-downs on Cushions (E)
and (F) to attach to chair.
F
E