Honeywell CF4680 User manual

CF4680 2D Imager Module
For Customer-Facing Designs
Quick Start Guide
CF4680-EN-QS Rev A
5/21

1
What is the CF4680 2D Imager Module?
The CF4680 is a 2D imager module designed to be integrated
into fixed mount enclosures, such as a self-service kiosk. It
includes:
• N4680 scan engine
• USB interface (USB-B connector)
•Exitwindow
• Movement detector used to start a reading session
• User feedback pins
Required Accessories
• Standard USB-A to USB-B cable
Additional Documentation
The following documents are available for the CF4680:
• CF4680 Installation Guide
• N4680/CF4680 User Guide
These documents are available from your local Honeywell OEM
representative.

2
CF4680 Front View
Mounting
holes (x4)
Exit
window

3
CF4680 Back View
Movement
detector
Ribbon cable
sensor to PCB
USB-B
connector
Distance selection
switch
User
feedback
pins
Scan
engine
Ribbon cable
engine to PCB

4
PCB View
1
2
1
6
1
5
1
Flex connector
to scan engine
Flex connector
to movement detector
USB-B
connector
User feedback
pins
Distance selection
switch

5
Connecting the CF4680 to a Host
By default, the CF4680 is in USB PC Keyboard interface.
1. Connect a standard USB cable (standard USB-A to USB-B)
to the CF4680 and to the USB port on the host.
2. Power-up the host.
3. Verify that the CF4680 is on by presenting a bar code in
front of the scan window. The white LED should turn on and
read the bar code.
Note: The CF4680 does not beep to indicate a good read unless
this has been setup by the user with the user feedback pins.
See the CF4680 Installation Guide for more details
(available from your local Honeywell OEM representative).

6
Distance Selection Switch
Use this switch to select the range to be used to detect an object
and trigger the scan engine. The distance is measured from the
outside of the exit window.
• Position 1—0 to 10 cm (4 in)
• Position 2—0 to 20 cm (8 in)
• Position 3—0 to 30 cm (12 in)
2
1
6
1
5
1
Position

7
Configuration
You can configure your scanner two ways:
• Reading configuration bar codes
• Using the EZConfig Cloud for Scanning tool
Configuration Bar Codes
Scan configuration bar codes to set up your scanner. All avail-
able configuration bar codes are available in the N4680/
CF4680 User Guide. Contact your local Honeywell OEM repre-
sentative for more information.
EZConfig for Scanning Tool
Use the EZConfig for Scanning tool to configure your scanner
Online:
1. Go to the Honeywell https://hsmftp.honeywell.com.
2. Register (if you haven’t already), then login.
3. Browse to Software >Barcode Scanners > Software > Tools
and Utilities > EZConfig for Scanning > Current and
download the tool.
4. Open EZConfig to configure your scanner.

8
Basic Setup
Here are some basic menu bar codes that may be useful for test-
ing. For more setup options see the N4680/CF4680 User Guide
(available from your local Honeywell OEM representative).
Note: The * symbol indicates the default value.
Interface
For USB serial interface, you must install the USB driver before
connecting your scanner. Contact your local Honeywell OEM
representative to get the latest USB driver.
USB Serial Interface
USB PC Keyboard *

9
Keyboard Country Layout
The default keyboard is United States.
French
German
Italian
All Symbologies
All Symbologies On
All Symbologies Off