Honeywell Οva-OmniLED R S User manual

GB
Ova/OmniLED R Spot
Centralized
175mm
100mm
37mm
21,5mm
70mm
Dimensional Drawings:
Honeywell Life Safety AS, Po. Box 3514, N-3007 Drammen, Norway http://www.hls-nordic.com
Installation:
To install this luminaire, a hole Ø 70 mm must be cut in the suspended ceiling. For correct mounting,
observe the light direction
Step 1: Connect the 24V cables to the terminal blocks, C1 and C2. Power supply cables cross section should
2
be 0.8 – 3 mm . After the connection of the cables, secure them with the provided cable tie. Place the
main unit on the false ceiling. For spot installation see the next page.
C1 C2
1
1
At the end of their useful life the packaging and product
should be disposed of via a suitable recycling centre.
Do not dispose of with your normal household waste.
Do not burn.
NOTE! The light source is non-user replaceable.
The light source contained in this luminary shall only be replaced by the manufacturer, or his
agent, or a similar qualified person.

GB
Honeywell Life Safety AS, Po. Box 3514, N-3007 Drammen, Norway http://www.hls-nordic.com
Weight:
Technical description
Part no.:
Lumen output:
o
-30 to 50 C
Up to 95%
IP20
Produced in accordance with: EN 60598-1, EN 60598-2-22
Ambient Temperature Range:
Maximum Power Consumption:
Operation Voltage: 15-30V DC, 17-27V AC, 50-60 Hz
270 lm
145 gr
3.5W / 3.7VA
138372
Οva-OmniLED R S LED 24V Centralized
Degress of cover protection:
Relative Humidity:
Technical lifetime (light source): > 100000 hours
2
5
4
3
Anti-Panic Area (AP)
Light direction
Escape Route (ER)
1
1
Step 3: Insert the cover with the lens on the luminary. Be carefull not to touch the LED with your hand.
Step 5: Bend the other spring and push the luminaire upwards until it is securely mounted. The device is
now ready to operate.
Step 2: Put the lens on the retaining cover.
Step 4: Bend one spring, to get into the holes of the suspended ceiling.
To install the spot place the main unit on the false ceiling and follow the next steps.
Step 1: In order to place the proper lens (Anti - panic or escape route), first be sure that the luminary is not
connected in the mains power supply and the battery is disconnected. A 5 lux lens (Part no.
2900XX.STR) is also available for order. Use the corresponding lens retaining cover depending on
the lens you will use.
Spot Installation: