HP LASERJET 2600 User manual

HP Color LaserJet 2600 series -- Maintenance Kit Instructions
www.printertechs.com
Please note that installing the fuser in this maintenance kit is considered an
advanced installation procedure. If you have never done this before you will
want to follow the steps carefully and allow extra time for installation.
Because of the advanced nature of the fuser installation, we can only provide
limited technical support for this kit.
Here is the outline of installation steps:
Step #1 – Replace the separation pad.
Step #2 – Replace the pickup roller.
Step #3 – Replace the fuser.

Paper pickup roller removal and replacement
Use the following procedures to remove the paper pickup roller.
1Open the front door.
2Remove the print cartridges.
ENWW Removal and replacement procedures 89

3Remove two (2) screws.
1Two (2) screws
4Remove the pre-transfer guide (RC1–5419–000CN).
5Use a small screwdriver to pull back on the tabs.
90 Chapter 5 Removal and replacement ENWW

3Remove two (2) screws from the right cover assembly (RM1–1858–000CN).
1Two (2) screws
4Remove the right cover assembly, carefully disengaging the catches.
5Unplug the control panel cable.
ENWW Removal and replacement procedures 75

6Insert a screwdriver to loosen the release tab on each side of the upper face cover.
7Remove the upper face cover (RC1–5174–000CN).
8Remove four (4) screws from the upper cover (RC1–5176–000CN).
76 Chapter 5 Removal and replacement ENWW

9Lift up and remove the face-down cover (RC1–5173–000CN).
10 Remove the output tray by releasing the tabs.
1Release tabs
11 Unplug the harness from the fuser motor.
ENWW Removal and replacement procedures 77

12 Open two (2) clips and remove one (1) clip to remove the fuser connector.
1Open clips
2Remove clip
1Fuser connector
2Remove clip from the board by pulling up
78 Chapter 5 Removal and replacement ENWW