human care 90706 User manual

User Manual
Wall bumber Floorline-i & Floorline-i Plus
90706

2www.humancaregroup.com
Content ENGLISH
User Manual 3
Compliances and Standards 4
Technical Specicaons 5
Responsibility of users 5
Safety Advice 6
Intended Use 7
Assembly/Disassembly Instrucons 8
Operaon Instrucons 10
Maintenance and service 11
Recycling 11

www.humancaregroup.com 3
ENGLISH
Symbols
WARNING symbol indicates a
potenally hazardous situaon which,
if not avoided, could result in serious
injury to the user or damage to
property and/or the device itself.
INFORMATION symbol indicates
recommendaons and informaon for
proper, trouble-free usage.
WEIGHT CAPACITY symbol indicates
maximum user weight for the product.
Do not exceed this weight in any
circumstance.
CE MARKING symbol indicates product
meets requirements of EU Direcve
93/42/EEC (MDD) and/or EU
Regulaon 2017/745 (MDR).
RECYCLE according to local regulaons.
READ INSTRUCTIONS and ensure you
fully understand them before using
this product.
Important!
You must read the user manual for the bed as well as the user manual for the
accessory prior to usage. Keep this booklet and informaon handy for future
use.
Product modicaon is not
permied.
Before use, always check that the
product is not damaged or worn.
Human Care’s products are connuously
being developed and updated to provide our
customers with the highest quality. We reserve
the right to make design changes without prior
noce.
Always make sure that you have the most
recent version of the manual which is available
for downloading from our website at
www.humancaregroup.com.
Contact your local distributor if you have any
quesons about the product and its use.
Noce to user/paent in case of serious
incident
Any serious incident that has occurred in
relaon to the product, should be reported
to the local contact, who reports to the
manufacturer, and the competent authority
of the country in which the user/paent is
established.
User Manual

4www.humancaregroup.com
Wall bumber, Floorline-i & Floorline-i Plus
Human Care is an ISO 13485:2016 cered
Swedish medical device company. The Quality
Management System is in compliance with US
21 CFR part 820.
The product is CE marked in accordance with
EU Direcve 93/42/EEC (MDD) and/or EU
Regulaon 2017/745 (MDR), as class I medical
device.
The CE mark is on the product.
This bed complies with all requirements
of the IEC/ISO Internaonal Standards: IEC
60601‐2‐52:2009
Compliances and Standards
This User Manual informs you, as the operator,
and your users, about the product features,
assembly and operang funcons necessary
to ensure ease of operaon, and safe handling
of this product in its normal and expected
environment.
You should therefore also regard this User
Manual, as a praccal reference book, to be
kept near the product and readily available
at all mes, for anyone involved in its use or
operaon.
Is a warning triangle used for situaons which
require extra care and aenon.
CAUTION!
Do not assemble or operate the bed accessory,
before reading this manual, as personal injury
or damage to product may occur!
Please contact Human Care in the event of any
uncertaines or quesons.
Product lifeme
The product´s expected lifeme is ten (10)
years, if the product is used as intended and
maintained according to the manufacturer´s
instrucons, depending on the intensity of use
and maximum load applied during use. If the
product label is no longer legible, the product
should be discarded.

www.humancaregroup.com 5
ENGLISH
Technical Specicaons
Responsibility of users
Instrucons for the operator:
Please pay aenon to your obligaons, as the
operator, in order to ensure the permanently
safe operaon of this medical product,
minimising risks to the paent, user and/or
third pares.
Any piece of technical equipment, electrical or
otherwise, can prove hazardous, if not properly
operated and maintained in accordance with its
User Manual. It is recommended that you are
informed of all operaons and perform regular
maintenance on equipment.
Denions:
Operator
(e.g.: clinic, hospital, hospital management,
nursing home), is every natural or legal person
with property rights over the bed (including
when subject to hiring, rental or lease
arrangements).
Responsibility for the safe operaon of
this bed accessory lies with the operator.
User
(specialist medical sta, nurses, doctors,
aendants and care sta) are persons who,
on the basis of their training, experience or
thorough instrucon, are entled to operate
the bed on their own responsibility, or to carry
out work on it, or who have received instrucon
in the handling of this bed. Furthermore, they
are able to recognize and avoid possible hazards
as well as assess the clinical condion of the
paents.
Paent, Resident or Guest
In this manual, a paent is described as any
person being ill, inrm, disabled, in need of
care, or otherwise occupying this bed.
Each me the bed accessory is allocated, it is
recommended that the paent is instructed in
all the funcons that are important for him/her,
by the operator or user.
Specifications (mm / inch)
Inner width 58 cm / 22.9”
Outer width: 35 cm / 13.8”

6www.humancaregroup.com
Wall bumber, Floorline-i & Floorline-i Plus
Safety Advice
Safety Symbol
In this manual the adjacent safety warning
symbol is shown as:
This safety symbol does not
replace all the wrien safety
advice. You are instructed to read the
safety advice and follow it precisely.
Safety for the operator
With the aid of this manual, which must be
handed over together with the product, you
must ensure that every user is instructed in the
safe operaon of the product before it is put
into service for the rst me.
Draw every user’s aenon to the possible
hazards that can arise if the product is not used
properly.
Pay aenon to your obligaons in order to
ensure the permanently safe operaon of this
product to minimise all risks to the paent, user
and/or third pares.
Regular preventave maintenance is the
Operator’s responsibility.
Only allow this product to be used by persons
who have been instructed in its safe operaon.
Make sure that stand‐in or temporary sta are
suciently well instructed in the safe operaon
of the product.
Safety advice for the user
Make sure that the operator instructs you in the
safe operaon of this product.
Each me, before using the product, check that
it is in perfect working order.
Make sure that there are no obstacles (eg:
bedside lockers, chairs, hoists, wall mounted
xtures, or equipment etc.) which could impede
any adjusng or movement of the bed.

www.humancaregroup.com 7
ENGLISH
Intended Use
The Wall Bumper Bar protects the head end of
the bed when moving the bed close to a wall
or an object that could damage the castors on
the bed.
Accessory intended for the following Floorline Beds
This accessory should only be used with
Floorline models from Human Care with the
following arcle numbers.
It is important that only Human Care accessories
are ed to Human Care beds, as any incompable
accessories can create hazards.
Product Name Article Number
Floorline-i EU 90300
Floorline-i AU 90301
Floorline-i US class 1 90302
Floorline-i UK 90303
Floorline-i Plus EU 90500
Floorline-i Plus AU class 1 90501
Floorline-i Plus AU 90502
Floorline-i Plus US class 1 90503
Floorline-i Plus UK 90504

8www.humancaregroup.com
Wall bumber, Floorline-i & Floorline-i Plus
Assembly/Disassembly Instrucons
Content:
Number Descripon Qty.
1Wall bumber 1
2 Self-drilling screw 4 mm 4
Wall bumber Floorline‐i & Floorline‐i Plus ‐ 90706
2
1

www.humancaregroup.com 9
ENGLISH
Assembly:
The Wall bumper shall be mounted to the lower
cross beam between the castors on the head end
of the bed. The Wall bumper shall be mounted so
that the bent‐up part of the bumper is poinng
upwards.
1. Hold the wall bumper to the center of the cross
beam between the castors and mark the holes
posion with a marker pen. The Wall bumper shall
be mounted with the slightly
2. Drill the four holes in the cross beam with a 3,5
mm metal drill.
3. Screw the Wall bumper to the cross beam with
the self‐drilling screws 4 mm

10 www.humancaregroup.com
Wall bumber, Floorline-i & Floorline-i Plus
Operaon Instrucons
When there is a risk of damaging the castor to
a wall or an object the Wall bumper can be used
to avid these damages.

www.humancaregroup.com 11
ENGLISH
Maintenance and service
Inspecon, care and maintenance
check list
User inspecons of this accessory should be
carried out together with the Floorline bed
every 6 months.
Check:
See bed description, accessories and
all functions
• Check for Damage/Cleanliness
• Confirm Secure
• Perform Adjustment/Cleaning
OK Faults:
Action
Cleaning
Parts to Order
VISUAL CHECK of the Components
Nuts/Bolts, Screws/Pins, Hinges/
Mounts/Bushes-component fixing
points
Wear/Damage, Tighten & Secure
Clean & Free
Painted steel components Intact, Clean & Securely Fitted
PERFORMANCE CHECK
Accessories Confirm Full Operation
Inspector’s Name: Inspector’s Signature:
Inspection result: Date:
If any problem persists, please call the customer service in your country.
Recycling
The product is built mostly from steel, or
stainless steel. The surfaces have been nished
with an electro‐coated powdercoang.
Incorrect disposal of this equipment and its
component parts may produce substances that
are hazardous to the environment. Dispose of
in accordance with all applicable naonal and
local regulaons.

HUMAN CARE SWEDEN (HQ)
Årstaängsvägen 21B
117 43 Stockholm
Phone: [phone]
Fax: [phone]
Email: [e-mail]
HUMAN CARE CANADA
10-155 Colonnade Road
Oawa, ON K2E 7K1
Phone: [phone]
Fax: [phone]
Email: [e-mail]
HUMAN CARE UNITED STATES
8006 Cameron Road, Suite K
Ausn, TX 78754 USA
Phone: [phone]
Fax: [phone]
Email: [e-mail]
HUMAN CARE NEDERLAND
Elspeterweg 124
8076 PA Vierhouten
Phone: [phone]
Fax: [phone]
Email: [e-mail]
www.humancaregroup.com
99930, Rev 1, ENG, User Manual, Wall bumper bar (FLi & FLi Plus), Apr 2022