IBM ThinkPad 390X User manual

Part Number: 08K8870
ThinkPad 390X Setup Guide
This guide provides information for setting up your computer for the first time.
Front View
Internal speakers
Internal speakers
System-status
indicators
TrackPoint
Liquid Crystal Display
(LCD)
Battery indicator
Suspend indicator
Brightness control
TrackPoint
buttons
CD-ROM drive Diskette drive Audio volume control
Microphone jack
Line-in jack
Headphone jack
Modem connector
PC Card eject buttons
PC Card slots
Rear View
PS/2 mouse
and keyboard
connector
Parallel
connector Hard disk
drive
Security
keyhole Serial
connector Power jack Universal serial bus(USB)
connector
Battery pack
Infrared port
Power switch
External-
monitor
connector
S-video jack
Notes:
1. The internal speakers are located on the lower edge of the LCD or on the front ends of the computer, depending on the model.
2. The modem feature is available only on select models.
 Copyright IBM Corporation 1999 1
All manuals and user guides at all-guides.com
all-guides.com

Bottom View
Tilt feet
Memory
door
Battery-pack
latch Bay LED
System-expansion
connectors
UltraBay FX
device lock
Electrical Safety Notice
DANGER
Electrical current from power, telephone, and com-
munication cables is hazardous. To avoid shock
hazard, connect and disconnect cables as shown
below when installing, moving, or opening the
covers of this product or attached devices. The
3–pin power cord must be used with a properly
grounded power outlet.
Turn everything OFF. First, attach all cables
to devices. Attach the signal cables to the
receptacles.
Attach the power
cord to an outlet. Turn the device ON.
To Connect
Turn everything OFF. First, remove the
power cord from
the outlet.
Remove the signal
cables from the
receptacles.
Remove all cables
from device.
To Disconnect
Note: In the U.K., by law:
The telephone line cable must be connected after the
power cord.
The power cord must be disconnected after the tele-
phone line cable.
Setting Up Your Computer
You are now ready to assemble and start your computer.
1. Insert the battery pack into the battery compartment located
near the left front end of the computer.
2
All manuals and user guides at all-guides.com

2. If you want to connect a printer to your computer, connect
one end of the printer cable to the parallel connector and the
other end to your printer. Then power on the printer.
3. Connect the AC Adapter to the computer's power jack (at the
rear of the computer) in the order shown.
1
2
3
4. Open the liquid crystal display.
Pull the liquid crystal display (LCD) latches (1) and open the
LCD (2). Then position the LCD so that it is convenient for
viewing.
2
1
1
5. Power on the computer.
a. Push and release the power switch (1). The power
switch automatically snaps back to its original position.
b. Adjust the display's brightness (2).
Brightness
1
2
 Copyright IBM Corporation 1999 3
All manuals and user guides at all-guides.com

Using the TrackPoint
The TrackPoint is a unique device for moving the cursor on the
screen. You can perform all mouse operations with the
TrackPoint. The left and right click buttons function like the left
and right click buttons on a mouse. For an explanation of the
center button, see the User's Reference .
To move the cursor, use the red-topped stick at the center of the
keyboard. Press gently with your left or right index finger in the
direction you want to move the cursor. To select and drag an
object, press and hold one of the click buttons with either thumb
as required by your software.
Click means to press the left click button once. Double-click
means to press the left click button twice within 1 second.
Cursor
Stick
Right click button
Center button
Left click button
For more information about the TrackPoint, see the User's Refer-
ence .
Customizing Your Computer
The ThinkPad Software Selections program provides a col-
lection of setup wizards to help you customize your computer for
your specific needs.
To start the ThinkPad Software Selections program, eject the
CD-ROM tray and insert the ThinkPad Software Selections
CD; then close the tray. Follow the instructions on the screen.
Registering Your Computer
After setting up Windows 98 or Windows NT, take a few
moments to complete the ThinkPad registration. The information
provided by you will help IBM to better serve you in the future.
For models with a modem, you can register electronically from
the Windows desktop. Do as follows:
1. Connect one end of the modem cable to the modem con-
nector on the computer's right panel and the other end to an
analog phone line.
4
All manuals and user guides at all-guides.com

2. Double-click on the Register icon.
3. Follow the instructions on the screen to complete the regis-
tration.
You can also register your computer at the following web
site:
http://www.pc.ibm.com/register
Getting More Information
After you have completed setting up your computer and
Windows, please read Chapter 1 of the User's Reference before
you start using the computer. If you want to learn more about
your computer and its options, see the following:
Using your computer outside your home country
Using audio, modem and DVD features
Protecting your computer
Using your computer with a battery pack
Using your computer with a PC Card
Resolving system resource conflicts
Solving computer problems
Installing software
Using system management
Handling the ThinkPad
Getting service
Note: To see the Online User's Guide , click Start, move the
cursor to Programs, ThinkPad 390X, then click ThinkPad
390X User's Guide.
User's Reference
Getting familiar with your computer
Extending the features of your computer
Protecting your computer
Solving computer problems
Getting service
Features and specifications
Product warranties and notices
Online User's Guide
 Copyright IBM Corporation 1999 5
All manuals and user guides at all-guides.com