idi Aspect 100UC Plus Q-CARD User manual

Aspect 100UC Plus Q-CARD
SETUP/PATIENT PREPARATION:
Moving table:
1) Unlock front and rear casters.
2) Position table to desired location.
3) Secure table mobility by locking front and rear casters.
AC Power:
1) Plug power cord into properly grounded outlet.
2) Protect power cord from damage by casters or other
equipment.
Controls:
1) Emergency Stop Pushbutton disables all tabletop motion
control when engaged.
2) Ensure that hand and foot controls are connected to table.
3) If tabletop motion controls fail to operate, make sure that the
Emergency Stop Pushbutton is NOT pushed in.
4) Actuate controls to ascertain that power is present and table
movement functions properly.
EMERGENCY PROCEDURES:
Stop Tabletop motion:
•Press Emergency Stop Pushbutton until it is fully engaged.
AC Failure:
•Internal battery allows tabletop motions to function. Return
tabletop to proper position to unload patient.
CPR:
Return table to level, center tabletop to minimize
overhang and lower table position to a comfortable
height to perform CPR.
CLEANING AND STORAGE:
1) Unplug power cord and wrap it around
the cord holder.
2) Push in Emergency Stop Pushbutton.
3) Set caster lock pedals to LOCK position.
4) Clean and disinfect table.
WARNING! Read operator
manual prior to use
Scan to
Access
User
Manuals
Online

•PUSH IN to stop
ALL tabletop motion.
•TWIST to reset.
L100-3137 Rev.A
Patients must be loaded from the side of table. Tilting or instability may occur if
patient is loaded onto the pedestal end or imaging end of the table.
Aspect 100UC Plus Q-CARD
EMERGENCY
STOP
PUSHBUTTON
HAND CONTROL
FOOT CONTROL
CONSUMABLES
•URO DRAIN BAGS
(BOX OF 20)
IDI #C000-0593
•DISPOSABLE FOOT
CONTROL COVERS
(BOX OF 50)
IDI #C000-0492
•DISPOSABLE TABLE
TOP PAD COVERS
(BOX OF 20)
IDI #C000-0645