idi Aspect 100-4 Q-CARD User manual

SETUP
Moving table to desired location:
1) Make sure all casters are unlocked
2) Position table
AC Power:
1) Plug power cord into properly grounded outlet
2) Protect cord from damage by casters or other
equipment
Controls:
1) Connect hand control and foot control (if equipped)
2) Lock all casters
3) Operate controls to ascertain power is present and
table functions properly
AC FAILURE
Internal battery allows table to be returned to a
position to safely remove patient
CPR
Retract tabletop and lower table position to a
comfortable height to perform CPR
CLEANING AND STORAGE
1) Lock casters
2) Unplug power cord
3) Clean and disinfect table.
WARNING!
Read operator manual prior to use
Aspect 100-4 Q-CARD
www.imagediagnostics.com

Aspect 100-4 Q-CARD
www.imagediagnostics.com
D100-2249 Rev. A
PANHANDLE CONTROL
This device clamps on the tabletop accessory rail and is movable. Depressing the
mushroom shaped handle enables lateral and longitudinal motion of the tabletop.
While holding the handle depressed, the tabletop can be manually repositioned.
Operating the rocker switch will cause the tabletop to raise or lower.
OPTIONAL FOOT
CONTROL
Controls tabletop motion
Note!
The pan handle 4-float brake
release will NOT function if
there is no AC power to the
table.
Note!
The foot control 4-float
brake release will NOT
function if there is no AC
power to the table.