iDPRT HPL3D2303 User manual

Quick Start Guide
Packing List
Quick Start Guide
Printer USB Cable
Appearance and Components
Front
Back
Roll Paper

Inside
Platen

USB Interface
Thermal Head



Window


Power LED
Error LED

LCD

AC Adapter
Belt Clip
Belt Clip Screw Hole





hook click into place.
Hook


Note

ADD:
TEL:
WEB:


www.idprt.com
HPL3D2303
CD
FCC COMPLIANCE STATEMENT:
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by the part responsible for compliance could void the user’s authority to
operate the equipment.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.

Paper Loading



mode.



◆ 
with a host device is disconnected.
◆ 

Note
Plug in socket with USB charging.


◆ 
◆ 


Note
Charging via AC Adapter
Charging via PC




sure that it is closed on both sides.
4. Use the tear bar to cut the extra paper.
 



Note: 




Label
Bluetooth
HM-T300PRO-9FEA
Ready