iDPRT iT4B User manual

Appearance and Components
Packing List
Note: The packing materials are actually based on the order. Xiamen Hanin Electronic Technology Co., Ltd.
ADD: 4F, 2#, Aide Airport Industrial Park, Huli District, Xiamen, China.
WEBwww.idprt.com
iT4B
Quick Start Guide
Printer AC Adapter Power Cord Label Roll Ribbon Spindles
Ribbon
Note: The packing materials are actually based on the order.
USB Cable Empty Ribbon Core CD
Quick Start Guide
Quick Start Guide
Front View
Front Cover
Power Buon
Printer Cover
Status Indicator
Feed Buon
Cover Open Buons
Rear View
USB Port
(Type B)
Ethernet Port
Power Receptacle
Moveable Roll Holders
Locking Tab
Inside View
Printer Mechanism
Mechanism Lock
Back Label Sensor
Front Label Sensor
Platen
Moveable Label Guides
FCC WARNING：This device complies with part 15 of the FCC Rules.
peraon is subect to the followin two condions
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
includin interference that may cause unde
sired operaon.
Any chanes or modicaons not epressly approved
by the party responsible for compliance could void the
user's authority to operate the equipment.
TE This equipment has been tested and found to
comply with the limits for a Class A diital device,
pursuant to part 15 of the FCC Rules. These limits are
desined to provide reasonable protecon aainst
harmful interference when the equipment isoperated
in a commercial environment. This equipment
enerates, uses, and canradiate radio frequency
enery and, if not installed and used in accordance
with the instrucon manual, may cause harmful
interference to radio communicaons. peraonof
this equipment in a residenal area is likely to cause
harmful interference in whichcase the user will be
required to correct the interference at his own
epense.
-- Reorient or relocate the receivin antenna.
-- ncrease the separaon between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected.
-- Consult the dealer or an eperienced radioT tech
nician for help.
To maintain compliance with FCCs RF Eposure
uidelines, This equipment should be installed and
operated with minimum distance between 20cm the
radiator your body Use only the supplied antenna.
Cauon:
This is a Class A product. In a domesc environment this
product may cause radio interference in which the user
may be required to take adequate measures.

Loading the Roll
Loading the Ribbon
Note: lease reer to indos drier installaon in iT ser anual.1.Press to open the printer cover and
mechanism.
2.Pull the roll holders open and place
the roll between them.Press down the
locking tab.
3.Pass the labels through label guides
and adjust label guides to label’s width.
1.Install the ribbon module. 2.Insert the le part of supply spindle
and then the right part spindle.
3.Press down the printer mechanism.
6.Press down the mechanism and close
the cover.
4.Insert the le part of rewind spindle
and then the right part.
5.Wind the core 2~3 ciPress down the
mechanism and close the cover.
3.Connect the other end of power cord to the outlet.
2.Connect the power cord to AC adapter.
1.Connect the AC adapter to power receptacle.
Varies by regions
Ribbon Supply Spindle
Ribbon Rewind Spindle
Sckup
Poer Connecon
Cauon: the tear bar
of this printer contains
a sharp edge. Please
do NOT touch it.