IFM Efector 200 O4P5 Series User manual

Operating instructions
Retro-reflective sensor
O4P5xx
704261 / 01 01 / 2009
UK
UK

2
Preliminary note1
Symbols used1.1
►Instruction
> Reaction, result
[…] Designation of pushbuttons, buttons or indications
→Cross-reference
Important note
Non-compliance can result in malfunctions or interference.
Functions and features2
In conjunction with a prismatic reflector or reflective tape the retro-reflective sen-
sor detects objects and materials without contact and indicates their presence by
a switching signal.
Range: (→type label).
Installation3
Fit the prismatic reflector or the reflective tape behind the object to be detected.►
Align the retro-reflective sensor to it and secure it to a bracket.►
Maximum range only with accurate alignment.

3
UK
Operating and display elements4
1
2
3
LED1:
[OUT on] button2:
[OUT off] button3:
Electrical connection5
The unit must be connected by a qualified electrician.
The national and international regulations for the installation of electri-►
cal equipment must be adhered to.
Ensure voltage supply to EN 50178.►
Disconnect power.►
Connect the unit as follows:►
Connector
L+
L
1
4
3
pin 1 = L+
(pin 2 = not connected)
pin 3 = L-
pin 4 = load
Cable
BN
BK
BU
L+
L
BN = L+
BU = L-
BK = load
Core colours: BN = brown, BU = blue, BK = black

4
Settings6
Sensitivity setting6.1
The sensor is to switch when the object is detected
1
Position the object.►
Press [OUT on] for 2 s.►
The sensitivity is set to the object. The LED flashes.>
2
Remove the object.►
Press [OUT off].►
The sensitivity is set without object.>
The LED goes out. The setting operation is completed.>
The sensor is not to switch when the object is detected
Position the object (see figure 1) and press [OUT off].►
Remove the object (see figure 2) and press [OUT on].►
The settings can also be carried out first without object (step 1) and then with
object (step 2).
Setting of maximum sensitivity6.2
Align the sensor so that no light is reflected.►
The sensor is to switch when the object is detected
First press [OUT on], then [OUT off].►
The sensor is to switch when the object is not detected
First press [OUT off], then [OUT on].►

5
UK
Setting unsuccessful6.3
The LED flashes quickly, 8 Hz.>
The sensor returns to the normal operating mode with unchanged values.>
Possible causes
Insufficient difference in measurements•
Max. programming time of 15 min. exceeded•
Electronic lock6.4
The unit can be locked electronically to prevent unauthorised setting. On delivery
the unit is not locked.
Press [OUT on] and [OUT off] simultaneously for 10 s.►
Acknowledgement is indicated by a change of the LED>
status.
To unlock repeat this step.►
Operation7
Check whether the unit operates correctly.►
Display by LEDs.>
Maintenance, repair, disposal8
Keep the lens of the sensor free from soiling.►
For cleaning do not use any solvents or cleaning agents which could damage►
the plastic parts.
After use dispose of the unit in an environmentally friendly way in accordance►
with the applicable national regulations.
Faulty sensors must only be repaired by the manufacturer.
Technical data and further information at
www.ifm.com →Select your country →Data sheet direct: