IFM Efector 200 O7E2 Series User manual

Operating instructions
Through-beam sensor
O7E2xx / O7S2xx
UK
UK
O7E200 / 00 10 / 2009

2
1 Preliminary note
1.1 Symbols used
►Instruction
> Reaction, result
→Cross-reference
Important note
Non-compliance can result in malfunctions or interference.
2 Functions and features
The through-beam sensor detects objects and materials without contact and
indicates their presence by a switching signal.
Range: →packaging or data sheet.
3 Installation
Transmitter Receiver
LED1:
Secure the receiver (O7E2xx) to a bracket.►
Align the transmitter (O7S2xx) to the receiver and secure it in the same way.►
Maximum range only with accurate alignment.
4 Electrical connection
The unit must be connected by a qualified electrician.
The national and international regulations for the installation of electri-►
cal equipment must be adhered to.
Ensure voltage supply to EN 50178, SELV, PELV.►

3
UK
Disconnect power.►
Connect the unit as follows:►
Transmitter (O7S2xx) DC
1
3
L+
L
Receiver (O7E2xx) DC PNP DC NPN
L+
L
1
4
3
L+
L
1
4
3
5 Operation
Check whether the unit operates correctly.►
Transmitter (O7S2xx): The green LED is lit when the sensor is ready for ope-•
ration.
Receiver:•
Dark-on switching units (O7E-DPKG): The output is switched / the yellow LED
is lit when an object is detected.
Light-on switching units (O7E-HPKG): The output is switched / the yellow LED
is lit when no object is detected.
6 Maintenance, repair and disposal
Keep the front panes of the sensor free from soiling.►
For cleaning do not use any solvents or cleaning agents which could damage►
the plastic material.
Technical data and further information at
www.ifm.com →Select your country →Data sheet direct: