IFM Efector 200 Series User manual

Operating instructions
Through-beam sensor
OGE3xx / OGS3xx
UK
UK
704461 / 01 01 / 2009

2
1 Preliminary note
1.1 Symbols used
►Instruction
> Reaction, result
→Cross-reference
Important note
Non-compliance can result in malfunctions or interference.
2 Functions and features
The through-beam sensor detects objects and materials without contact and
indicates their presence by a switching signal.
Range: (→type label).
3 Installation
11
LED1:
Install the receiver (OGE3xx) and secure it to a bracket.►
Align the transmitter (OGS3xx) to the receiver and secure it in the same way.►
Maximum range only with accurate alignment.
4 Electrical connection
The unit must be connected by a qualified electrician.
The national and international regulations for the installation of electri-►
cal equipment must be adhered to.
Ensure voltage supply to EN 50178.►
Disconnect power.►
Connect the unit as follows:►

3
UK
Transmitter (OGS3xx) connector
1
3
L+
L
pin 1 = L+
(pin 2: not connected)
pin 3 = L-
(pin 4: not connected)
Transmitter (OGS3xx) cable *
L+
L
BN
BU
BN = L+
BU = L-
Receiver (OGE3xx) connector
L+
L
1
4
3
pin 1 = L+
(pin 2 = not connected)
pin 3 = L-
pin 4 = load
Receiver (OGE3xx) cable *
BN
BK
BU
L+
L
BN = L+
BU = L-
BK = load
* Core colours: BN = brown, BU = blue, BK = black
5 Operation
Check whether the unit operates correctly.►
Transmitter (OGS3xx): The green LED is lit when the sensor is ready for•
operation.
Receiver:•
Dark-on switching units (OGE-DPKG): the output is switched / the yellow LED
is lit when an object is detected.
Light-on switching units (OGE-HPKG): the output is switched / the yellow LED
is lit when no object is detected.

4
6 Maintenance, repair and disposal
Keep the front lenses of the sensor free from soiling.►
For cleaning do not use any solvents or cleaning agents which could damage►
the plastic material.
Technical data and further information at
www.ifm.com →Select your country →Data sheet direct: