IFM OG Use and care manual

OG AC/DC Sensor Calibration
Align sensor to point toward the object you wish to detect.
Fasten securely.
Push and hold button until red LED flashes quickly for 2
seconds. The LED will continue to flash with equal on/off
pulses.
Press button once with no object in detection area. The
red LED will briefly go out and then continue to flash.
Press button again with the object in detection area. The red
LED will go out for 2 seconds, then return to operating
mode. If red LED flashes rapidly for 2 seconds, calibration is
not possible. This may be due to a marginal application or
misadjustment of the sensor. Adjust and retry the application.
1
2
3
4
TEL: [phone] • FAX: [phone]
www.ifmefector.com
10/02
Lit. No. B21002
Pushbutton
Red - marginal
signal, output
status
Pushbutton Calibration
OG AC/DC calibration card 11/19/02 10:22 AM Page 1

OG AC/DC Sensor Calibration
Do not use a screw-
driver or other sharp
object to press
pushbutton.
Use a ballpoint pen
or similar object
(such as hex wrench)
to press pushbutton.
Wiring
TEL: [phone] • FAX: [phone]
www.ifmefector.com
10/02
Lit. No. B21002
MICRO AC CONNECTOR WIRE SENSOR TRANSMITTER
PIN COLOR
2 Red - Black trace L1 or V+ L1 or V+
3 Red - White trace Output L2 or V-
(sensor view)
2
3
OG AC/DC calibration card 11/19/02 10:22 AM Page 2