iLiving ILG8MF30-83 User manual

1
30” HIGH VELOCITY DRUM FAN
MODEL: ILG8MF30-83
115V 60Hz
Owner’s Manual
PLEASE READ AND
SAVE THESE INSTRUCTIONS

2
TABLE OF CONTENTS
Important Instructions………………………………………. 3
Specifications ………………………............................... 5-6
Operating Instructions……………………….………....… 6
Maintenance and Cleaning………………………………. 7
Troubleshooting……………………………………………. 8

3
IMPORTANT INSTRUCTIONS
CAUTION: Please read and save these instructions. Do not use the fan if any part is
damaged or missing. Automatic reset safety device in motor. To reduce risk of injury
disconnect power supply before servicing.
Protect yourself and others by observing all safety information. Failure to comply
with instructions could result in personal injury and/or property damage!
Retain instructions for future reference.
WARNING: To reduce the risk of electric shock, do not expose the fan to water or
rain. To reduce the risk of fire or electric shock, do not use
this fan with any solid state speed control device. This
appliance has a grounded plug. To reduce the risk of fire
or electric shock, this plug is intended to fit in an outlet
only one way. If the plug does not fit into the outlet,
contact a qualified electrician. Do not attempt to bypass
this safety feature.
General Safety Information
1. Ensure that the power source conforms to the electrical requirements of the fan.
2. Where a two-prong wall receptacle is encountered, it must be replaced with a
properly grounded three prong receptacle installed in accordance with the United
States National Electrical Code (NEC) and all applicable local codes and ordinances.
This work must be done by a qualified electrician, using copper wire only.
3. Where possible, avoid the use of extension cords. If they must be used, minimize
the risk of overheating by ensuring that they are UL Listed and of the proper gauge
and length. Never use a single extension cord to operate more than one fan.
4. Do not kink the cord or allow it to contact oil, grease, chemicals, hot surfaces, or
sharp or abrasive objects.
5. This fan is to be operated ONLY with its OSHA compliant guards in place to prevent
persons and/or objects from contacting the revolving propeller. Any other use voids
warranty and may create unsafe conditions.
6. Fan is intended for general air circulation ONLY. It must NOT be used in potentially
dangerous locations such as flammable, explosive, chemical-laden, or wet
atmospheres. Do not use fan in or near a window, since rain may create an electrical
hazard. Do not attach ductwork to the fan.
7. Fan motor is equipped with an automatically resetting control circuit that will
disconnect power if the motor overheats. Always unplug fan before removing guard,

4
as motor may restart unexpectedly.
8. Do not operate any fan with a damaged cord or plug. Discard fan or return to an
authorized service facility for examination and/or repair.
9. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or
similar coverings. Do not route cord under furniture or appliances. Arrange cord
away from traffic area and where it will not be tripped over.
10. Disconnect the fan when moving it from one location to another.
11. Make sure the fan is on a stable, flat surface while it is in operation.
12. Disconnect the fan when removing the guards for cleaning.
13. This fan is suitable for commercial or industrial use only, not for household or
residential use.
WARNING - Use of a three-prong to two-prong adapter is not
recommended. Improper connection may create the risk of electrocution.
Use of such adapters is prohibited in Canada.
WARNING - Do not depend on any switch as the sole means of
disconnecting power when installing or servicing the fan. Failure to do so
may result in fatal electrical shock.
WARNING - Do not insert fingers or foreign objects into the fan. Do not
block or tamper with the fan in any manner while it is in operation.
WARNING - Do not touch motor. May be hot enough to cause injury.
WARNING - Unplug prior to servicing unit.
WARNING - To reduce the risk of fire or electric shock, do not use this fan
with any speed control device.
SAVE THESE INSTRUCTIONS

5
SPECIFICATION
Model: ILG8MF30-83
Parts of the fan
A
Handle (SP-ILG8MF30-83-A)
F
Rear Guard (SP-ILG8MF30-83-F)
B
Barrel (SP-ILG8MF30-83-B)
G
Control Box (SP-ILG8MF30-83-G)
C
Adjustable Triangle Knob
(SP-ILG8MF30-83-C)
H
Motor (SP-ILG8MF30-83-H)
D
Rubber Feet (SP-ILG8MF30-83-D)
I
Power Cord (SP-ILG8MF30-83-I)
E
Front Guard (SP-ILG8MF30-83-E)
J
Wheel (SP-ILG8MF30-83-J)
A
B
C
D
E
F
G
H
J
I

6
Product Specifications
Voltage
115V, 60Hz
Current
2.3A
Power
260 Watts
RPM
1100
OPERATION INSTRUCTION
1. Plug the power supply cord into a grounded wall outlet.
(115VAC, 60Hz)
Important: This air circulator comes with a grounded (three prong) plug.
The grounded plug must be used with a grounded outlet.
2. Turn the control knob to LOW, MED or HIGH to set to the desired
speed.
Control Box
Horsepower 1/5 HP
Speeds 3 SPEEDS
CFM 8300 / 6200 / 5550
Noise Level < 70.5 DBA

7
MAINTENCE AND CLEANING
WARNING:Parts replacement and troubleshooting to be performed only
by qualified personnel.
WARNING:Do not depend on any switch as the sole means of
disconnecting power when installing or servicing the fan. Failure to do so
may result in fatal electrical shock.
WARNING:Unplug the fan from the wall outlet before servicing or
cleaning.
CAUTION: There is no user maintenance part except regular cleaning as
following description. All other servicing or maintenance should be
performed by qualified service personnel.
To clean the fan, use a soft damp cloth. Wipe down with a dry cloth.
Do not use cleaners that are harmful to paints or plastics.
CAUTION: Do not use gasoline, benzene, thinner, harsh cleaners, etc.,
which are dangerous and will damage the air circulator.
The propeller, guard, and motor should be cleaned periodically to
prevent overheating, and/or operating in an imbalanced condition.
CAUTION: If cleaning requires the removal of a guard, remove only the
front guard and re-install when finished in its originally installed position.
Do not repair propeller if it becomes damaged. The propeller is
accurately balanced at the factory and should be replaced if damaged.
Do not bend the propeller. The propeller is accurately balanced at the
factory and should be replaced if damaged.
Do not repair propeller if it becomes damaged.
IMPORTANT: Ensure that propeller is replaced in correct direction as
factory installed.
Motor is permanently lubricated.

8
TROUBLE SHOOTING
If your fan fails to operate, please follow these Instructions:
1. Make sure the fan is plugged in and the electrical outlet is working
properly.
2. Check for any obstruction. If you find an obstruction, turn the fan
“OFF”. Unplug the fan and carefully remove the obstruction.
Plug the fan in and turn it on again. It should resume normal operation.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR FAN, PLEASE DO NOT
ATTEMP TO OPEN OR REPAIR THE FAN YOURSELF. DOING SO COULD
CAUSE DAMAGE TO THE FAN AND/OR PERSONAL INJURY. Always consult
the manufacturer before further use.

9
Or visit iLivingUSA.com/register-product
Feedback
Love it? Help us make the product more for you.
Let us know with a customer review.
Please visit: https://www.amazon.com/review/review-your-purchases#
At iLiving USA, we are committed to bringing top quality products to our customers.
iLIVING USA
860 Mahler Road,
Burlingame, CA 94010
Tel: [phone]
Email: [email protected]
Warranty Information
This product comes with a 1-YEAR LIMITED COMPONENT WARRANTY. If your unit does not appear
to be working properly, please contact our service center by calling 1-800-317-1688. Prior to your call,
we encourage you to visit our service related website www.ilivingusa.com for troubleshooting tips and
service instructions if needed.
Register your product at our website: