full half-full discharged
2 On/off switch
3 Screw sleeve
To access the operating elements (5) to (7) and
the battery compartment on the rear side, un-
screw the sleeve.
4 Threaded ring for the screw sleeve (3)
5 Buttons and to set the channel group, the
channel number and the microphone sensitivity
6 Button SET: To change the channel group, the
channel number or the microphone sensitivity,
press the button SET repeatedly until the corre-
sponding numerals start flashing on the display
(1). While the numerals keep flashing, make the
settings with the buttons and .
7 Switch RF for the transmission power
position L: low transmission power (2.5mW)
position H: high transmission power (25mW)
8 Sensor for the IR signals for automatic channel
setting
2 Important Notes
The wireless microphone corresponds to all relevant
directives of the EU and is therefore marked with .
•
The microphone is suitable for indoor use only.
Protect it against dripping water and splash
water, high air humidity and heat (admissible
ambient temperature range 0–40°C).
•
For cleaning only use a dry, soft cloth; never use
water or chemicals.
•
No guarantee claims for the microphone and
no liability for any resulting personal damage or
material damage will be accepted if the micro-
phone is used for other purposes than originally
intended, if it is not correctly operated, or if it is
not repaired in an expert way.
If the microphone is to be put out of oper-
ation definitively, take it to a local recycling
plant for a disposal which is not harmful to
the environment.
3 Applications
To provide a wireless audio transmission system,
combine this dynamic hand-held microphone with
integrated multi-frequency transmitter with the
following receivers from IMG STAGELINE:
TXS-606 with 1 receiver unit
TXS-626 with 2 receiver units
TXS-646 with 4 receiver units
TXS-686 with 8 receiver units
The transmission frequency within the UHF
range 672.000–696.975MHz is freely selectable
(frequency spacing 25kHz).
Due to the ACT function (automatic channel
targeting), the audio transmission system is very
easy to operate: Simply press a button and, via IR
signal, the wireless microphone is set to the chan-
nel selected on the receiver.
3.1 Conformity and approval
Herewith, MONACOR INTERNATIONAL declare that
the wireless microphone TXS-606HT complies with
the directive 2014/53/EU. The EU declaration of
conformity is available on the Internet:
www.imagestageline.com
This wireless microphone may be operated in the
following countries:
DE
In the Federal Republic of Germany, the wireless
microphone requires a frequency assignment (for
which a fee is charged).
In other countries, it is necessary to apply for a cor-
responding approval. Prior to operating the wire-
less microphone outside Germany, please contact
the MONACOR subsidiary or the corresponding
authorities of the respective country. Links to the
national authorities can be found via the following
Internet address:
www.cept.org
tECC
tTopics/Info
tSRD* Regulations and indicative list of equip-
ment sub-classes
tTools and Services
tEFIS − ECO Frequency Information System
tNational Frequency Tables
*Short Range Devices
