Infineon TLE9562 User manual

1
restricted
2022-02-24
Quick-start of the TLE9562 shield with
the uIO stick

2
Copyright © Infineon Technologies AG 2021. All rights reserved.restricted2021-02-08
›Set the jumpers for the LED connected to VCC1
and to enable the software development mode
›Connect the uIO stick to the shield and to the PC
›Enable the 12V supply
–The green LED should be on
Step 1

3
Copyright © Infineon Technologies AG 2021. All rights reserved.restricted2021-02-08
›Start the Config Wizard for the motor system IC and start
›The GUI should look like that: showing the that uIO stick communicate
with the TLE9562
Step 2
For example the charge pump is disabled

4
Copyright © Infineon Technologies AG 2021. All rights reserved.restricted2021-02-08
›Clear failures (if any)
Step 3

5
Copyright © Infineon Technologies AG 2021. All rights reserved.restricted2021-02-08
›Load the file:
–File Load
–A pop-up window appears Discard
–Browse and select the file TLE9562_ConfigWizard_2020_06_25_1.icwp (unzip the file before)
Step 3

6
Copyright © Infineon Technologies AG 2021. All rights reserved.restricted2021-02-08
›The pre-settings are loaded into the TLE9562, for example, the charge pump is enabled, the half-
bridge 1 is set in PWM, the charge and discharge currents and timings for the gate drivers are
configured
Step 3

7
Copyright © Infineon Technologies AG 2021. All rights reserved.restricted2021-02-08
Step 4 –Activate the motor connected between OUT1 and OUT2
›Enable the PWM1 generator by the uIO stick and applied to the PWM1 pin of the TLE9562,
set the duty cycle
›Turn on the low-side 1 (PWM MOSFET)
›Turn on the high-side 2

8