InFocus SP-LAMP-092 Guide

Lamp Module Replacement Instructions: SP-LAMP-092
1) Turn off the projector and unplug the power cord.
Wait 60 minutes to allow the projector to cool
thoroughly.
2) Loosen screws on the lamp compartment cover.
3) Remove lamp compartment cover.
NOTES:
Always use the InFocus lamp module designed for your projector model. Using the wrong lamp module may cause premature lamp failure and possible damage to the
projector.
SP-LAMP-092: IN3134a, IN3136a, IN3138HDa
You can order new lamps from www.infocus.com (in select areas), your retailer or your dealer.
Only genuine InFocus lamps are tested for use in this projector.
Use of
non InFocus lamps may cause electrical shock and fire, and may void the projector warranty. InFocus is not liable for the performance, safety or certification of any other
lamps.
WARNINGS:
•The projector uses a high-pressure mercury glass lamp. The lamp may fail prematurely, or it may rupture with a popping sound if jolted, scratched, or handled while
hot. The risk of lamp failure or rupture also increases as the lamp age increases; please replace the lamp when you see the “Replace Lamp” message.
•To avoid burns, allow the projector to cool for at least 60 minutes before you replace the lamp.
•Unplug the power cord before replacing the lamp.
•Do not drop the lamp module. The glass may shatter and cause injury.
•Do not touch the glass surface of the lamp module. Fingerprints can obscure projection sharpness and may cause the glass to shatter.
•Be extremely careful when removing the lamp module. In the unlikely event that the lamp ruptures, small glass fragments may be generated. The lamp module is
designed to contain most of these fragments, but use caution when removing it.
•Before replacing a ruptured lamp, clean the lamp compartment and dispose of cleaning materials. Wash hands after lamp replacement.
•When replacing the lamp while the projector is ceiling-mounted, wear protective eyewear to prevent eye injury.
•Hg-Lamp contains mercury. Manage with accordance with local disposal laws. See
www.lamprecycle.org

4) Remove the three screws from the lamp module.
Note
: If the projector is installed on a ceiling
mount, be careful not to drop the lamp module
once the captive screws are loosened.
5) Lift the module handle up and pull firmly on the
module handle to remove the lamp module.
Dispose of the lamp in an environmentally proper
manner.
6) Reverse steps 1 to 5 to install the new lamp
module. While installing, align the lamp module
with the connector and ensure it is level to avoid
damage.
Note:
The lamp module must sit
securely in place and the lamp connector must
be connected properly before tightening the
screws.
7) Plug in the power cord and press the
Power
button to turn the projector back on.
8) To reset the lamp hour timer, navigate to the
Settings 2
>
Advanced 1
menu and select
Lamp Hour Reset
.
9) Press the ▼▲◄► buttons in sequence to reset
the lamp timer.
10) Press the
Menu
button to return to the Settings 2
menu.