Intermec 074788 Series User manual

The printer shoulder strap (P/N 074788-xxx) provides you with a convenient way to
carry your PB21, PB22, PB31, PB32, PB42, PB50, PB51, or PW50 printer. The wide
padded strap makes it comfortable to wear the printer for long periods of time.
The shoulder strap kit contains these parts:
•Shoulder strap accessory
•These instructions
To attach the shoulder strap to the mobile printer (PB2X, PB3X, PB4X, PB5X)
1Install the handstrap on the printer.
2Orient the shoulder strap so that the textured side of the strap padding is facing
toward the printer. You want the textured side of the padding to sit on your
shoulder when the strap is installed.
3Attach the snap hooks on the ends of the shoulder strap to the D-rings on the
handstrap.
You are now ready to use the printer with the shoulder strap accessory.
To attach the shoulder strap to the PW50
1Orient the shoulder strap so that the textured side of the strap padding is facing
toward the printer .You want the textured side of the padding to sit on your
shoulder when the strap is installed.
Printer Shoulder Strap Instructions
Handstrap
D-ring
(2 places)
Shoulder strap

Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel [phone]
fax [phone]
www.intermec.com
© 2010 Intermec Technologies
Corporation. All rights reserved.
Printer Shoulder Strap Instructions
*943-160-004*
P/N 943-160-004
2Open one of the the snap hooks and insert it parallel to the bar on one side of
the PW50. Then, rotate the snap hook until it catches the bar and release the
latch.
3Repeat Step 2 with the other snap hook.
You are now ready to use the PW50 with the shoulder
strap accessory.
Note: If you have a handstrap installed, attach one of the snap hooks to
the D-ring on the handstrap.
Handstap
D-ring