Intermec PB42 Manual

PB42 and PB50
Handstrap Instructions
The handstrap (P/N 074789) provides a convenient way to carry your PB42
or PB50 printer. With the handstrap attached, you can also attach the
shoulder strap (P/N 074788). The handstrap kit contains these items:
• Handstrap accessory
• This instruction sheet
To attach the handstrap
1Remove both ends of the handstrap from the strap adjusters that secure
them to the strap.
2Insert one end of the handstrap through the handstrap clip on the printer.
Make sure the D-rings on the handstrap are facing away from the printer.
3Pull the end of the handstrap through the handstrap clip and then insert
the end of the handstrap back through the strap adjuster and pull tight.
4Repeat step 3 with the other end of the handstrap. You are now ready to
use the printer with the handstrap, or you can attach a shoulder strap to
the D-rings on the handstrap.
D-ring
Strap adjuster
Handstrap
clip

Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel [phone]
fax [phone]
www.intermec.com
©
2007 Intermec Technologies
Corporation. All rights reserved.
PB42 and PB50 Handstrap Instructions
*074579-002*
P/N 074579-002