Intermec CN3 Series User manual

Spacers are installed on the CN3 terminal holder to allow for optimum fit of the
holder on the 6822 portable printer.
To install the spacers
1Center a spacer on each mounting post and press firmly to seat.
2Align the terminal holder on the printer and insert the screws in the four
mounting holes.
3Using a Phillips screwdriver, tighten the screws to 0.45 to 0.68 Nm (4 to 6 in-lb).
CN3Terminal Holder Spacer Installation
Instructions
Screw (4 places)
Spacer
(4 places)

Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel [phone]
fax [phone]
www.intermec.com
©2008 Intermec Technologies
Corporation. All rights reserved.
CN3 Terminal Holder Spacer Installation Instructions
*943-197-001*
P/N 943-197-001