Jacuzzi Dome For Shower Surround System None User manual

© Copyright 1994 Jacuzzi Whirlpool Bath E540000 8/13/04
Jacuzzi Whirlpool
P.O. Box 702168, Dallas, TX 75370-2168
Customer Service: Call [phone]
Important: Read complete instructions before beginning installation.
ThecleardomeisacompanionproducttoourShowerSurroundSystemforusewiththeStreamPro™steamgenerator
and is available in many sizes to match the Shower Surround shapes.
Printed in the U.S.A.
Printed on Recycled Paper
PRODUCT SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
USE INSTALLATION INSTRUCTIONS SUPPLIED WITH PRODUCT.
Jacuzzi Whirlpool Bath has obtained applicable code (standards) listings generally available on a national basis for products of this type.
Itistheresponsibilityoftheinstaller/ownertodeterminespecificlocalcodecompliancepriortoinstallationofthisproduct. JacuzziWhirlpool
Bath makes no representation or warranty regarding, and will not be responsible for any code compliance.
APPLY TAPE TO THE
OUTER EDGE OF THE
DOME (ALLAROUND)
NONABSORBENT
TAPE
TOP
BOTTOM
RESTS ON
TOP OF
SHOWER
WALL
BOTTOM VIEW
OF DOME
FRONT
BACK
Installing the Sealing Strip
1. Beforeinstallingtheenclosednonabsorbenttapemakesurethatthesurfaceofthedomeiscleananddry. Amild
liquid detergent and warm water will clean soiled surfaces. Do not use abrasives, alcohol, ammonia or other
solvents.
2. Cut four strips of the sealing material from the roll provided. The first two should be cut to the length of the dome
flanges; the backing material (release liner) should then be removed and the strips adhered to the flanges.
3. Repeatsteptwoabovewithshorterstripscut to fit betweentheprevioustwo strips on theshortsidesof the dome.
The dome is then placed with the sealing surface onto the top ledge of the Shower Surround panels.
DOME FOR SHOWER
SURROUND SYSTEM
INSTALLATION INSTRUCTIONS