jbc AD-SC User manual

STANDS
www.jbctools.com

2
STANDS
CONTROL UNIT
TOOL
STAND
CONNECTION
STAND 0011283
CONNECTION CABLE 1m
0010154*
CABLE FLANGE
*Only in DR-SC and
DS-SC stand
STANDS
ww w.j bct ool s.c om

3
For HT420-A tweezers
HT-SC
For T245-A, T210-A
soldering handpiece
For PA120-A micro tweezers
PA-SC
For AP130-A solder feed iron
AP-SCAD-SC
For DR560-A desoldering iron
DR-SC
For DS360-A micro desoldering iron
DS-SC
All these stands can be connected to the following JBC stations: DI, DD, DM.

4
2 Insert the cartridge to be used into
the handpiece, push slightly and
remove it from the slot.
With the JBC system, the cartridge can be changed quickly, without turning off the station,
so you have multiple soldering irons in one.
1 Insert the cartridge connected to
the handpiece in a slot and pull
up slightly to release it.
3 Press the cartridge into the suitable
hole depending on the tip’s shape.
Important
It is essential to insert the cartridge till the end for a good connection.
Use the mark as reference.
Alignment
STANDS
CARTRIDGES EXTRACTOR INSERTER

5
Assembly for AD, AP, PA, HT stands.
CABLE COLLECTOR ASSEMBLY
Assembly for DR and DS stands. 0010154
CABLE FLANGE

6
Stand cable extension
Ref. A1286
Lenght: 1.5 m
0011283
Connection
cable
Suction tube extension kit
Ref. A1287
Lenght: 1.5 m
STANDS
CABLE STAND AND SUCTION TUBE EXTENSIONS
HT-SC TOOL PLACEMENT FOR BIG TIPS

7
ACCESSORIES
CL9885 TIP CLEANING STAND
The most complete cleaning accessory, allowing you to choose between 3 different cleaning methods:
metallic wool, metal brush and sponge. Use the integrated wiper to remove excess solder from the tip, you
can tap the tip on the wiper profile or you can wipe any possible particle stuck to the tip using the slots.
Due to its weight and antislip bumpers, it is totally self contained, portable and ideal 1 for handed use, there
is no need to hold with a hand while you are cleaning the tip.
CL0236 WIPER
S0354 SPONGE
CL6210 Brass wool
CL6205 Inox wool
CL6220 Brushes

This product should not be
thrown in the garbage.
WARRANTY
JBC’s 2 years warranty guarantees this equipment against all manu-
facturing defects, covering the replacement of defective parts and
all necessary labour.
Warranty does not cover product wear due to use or mis-use.
In order for the warranty to be valid, equipment must be returned,
postage paid, to the dealer where it was purchased enclosing this
fully filled in, sheet.
www.jbctools.com
SERIAL Nº
STAMP OF DEALER
DATE OF PURCHASE
0011683-0212