John Lewis Levity User manual

Recommended bulb
This product contains a non-replaceable LED Module. If the LEDs become damaged then the unit
must be replaced.
When moving or cleaning, always switch off at the mains and allow the module to cool before
handling.
John Lewis Partnership
171 Victoria Street
London SW1E 5NN
johnlewis.com
Made in China 18/12/2017
We have taken great care to ensure that this product reaches you in perfect condition.
However, should any parts be damaged or missing please contact the Product Helpline on
[phone].
This symbol indicates that this product should not be treated as normal household waste
and it should be recycled. John Lewis do not operate instore take back, but as members of the
Distributor Trade Back scheme have funded the development and upgrade of recycling facilities
across the UK. Please take it to your nearest collection facility or for further details contact your
local council or visit www.recycle-more.co.uk.
User manual
Levity
Floor light
Specifications
Maximum Power: 20W & 4W LED Module
Voltage: 24V DC
IP Rating: IP20
Weight: 6.44kg
Please keep these instructions for future reference.
Care Instructions
We recommend cleaning with a soft dry cloth. Do not use abrasive materials as these will damage
the finish.

Thank you for purchasing this Levity floor light. Please read the instructions carefully before use to
ensure safe and satisfactory operation of this product.
Warnings!
Please read these instructions carefully before commencing any work.
For your safety, always switch off the supply before cleaning or removing shades.
Your standard lamp has been packaged as five separate parts to prevent damage during transit.
When manoeuvring or assembling this product, it must be lifted from the bottom.
The LED module in this lamp is non-replaceable. If the LEDs cease functioning then the whole unit
must be replaced.
Assembly
Refer to assembly drawing opposite. Carefully unpack the carton, making sure all the parts are
present before assembly.
Step 1
Do not attempt to plug in or use this product until it has been fully assembled. Disconnect from
mains during assembly or maintenance.
Step 2
Remove all packaging from the base, the central tubes and shade. Remove any cable protection
pieces in the ends of the tubes.
Step 3
Locate tubes A and B into the sockets on the shade. Secure the shade in place by tightening the
screws using the supplied hex key. Do not overtighten.
Step 4
Screw Tubes C and D on to the central panel in a clockwise direction.Take care not to trap the
cable or cross the thread.
Step 5
Locate the end of Tubes C and D on to the base. Gently pull any excess cable through from Tube
D under the base. Fit the washers and nuts onto the threads and securely tighten using the supplied
spanner.
Step 6
Stand the product upright and check the tightness of the joints.
Step 7
Your standard lamp is now ready to use. Attach the power cable to the plug and plug in to the
mains supply. Switch on with the switch on the central panel.
Shade
Allen key
and screws
Tube B Tube A
Central
panel
Tube D Tube C
Base
Spanner Fixing nuts &
washers
Plug
Parts List
Allen
screws 2
Central
tubes 4
Plug 1
Shade 1
Central
panel 1
Base 1
Spanner 1
Allen key 1
Fixing
kit 2