01 02
Parts list Qty
Introduction Thank you for purchasing this Swing Arm Floor Lamp.
Please read the instructions carefully before
use to ensure safe and satisfactory operation
of this product.
Warnings This is a Class ll product and must NOT be earthed.
Please read these instructions carefully before commencing any work.
Your standard lamp has been packaged as separate parts to prevent damage
during transit.
When manoeuvring or assembling this product, it must be lifted from
the bottom section.
The lamp must be protected by a 3 amp fuse in the mains plug.
If you are in any doubt, please consult a qualied electrician.
For your safety, always switch off the supply before cleaning or adjusting.
If the mains cable becomes damaged it must only be replaced by a technically
competent, qualied person.
Recommended bulb
Product assembly
1
2
B
A
Recommended bulb (not included)
1 x 7W E27 LED Energy Efcient GLS, or
1 x 28W E27 Eco Halogen GLS, or
1 x 40W (Max.) E27 GLS
When changing a bulb, always switch off at the mains and allow the bulb to cool
before handling. Dispose of used bulbs carefully. Do not exceed the rated power
stated or use a different shape bulb from that indicated on the tting.
Carefully unpack the carton, making sure all the parts
are present before assembly.
Join the upper (A) and middle (B) sections of stem
into the lower section (C). Screw together taking care
not to trap cable or cross threads.
Gently pull through any excess cable from the base.
Turn the completed assembly anticlockwise
approximately 6 times. (Turning the tubes anticlockwise
rst ensures that the cable will straighten when the
tubes are fully assembled). Screw the assembly in a
clockwise direction on to the base (E). Take care not
to trap the cable or cross the threads, rmly tighten
the tube by hand.
Once stem is tted, attach felt pad (F) by sticking to
the base.
Fit the shade (G) by slotting over the lampholder
and secure with the shade ring (H). Fit the bulb (I).
Plug the lamp in and switch on using the foot switch.
The shade position can be adjusted by moving the arm.
Hold the stem and move the arm by the tube under
the shade.
Please note, the arm swivel joint is limited to around
300 degrees rotation. If the arm is rotated beyond
the stop, the stem may begin to unscrew. Take care
not to over-rotate the arm.
C
Light tting 1
Shade (G) 1
Felt Pad (F) 1
E
D
G
H
I
F
