Thank you for purchasing this John Lewis Emilia crystal wall light.
carefully before use to ensure safe and satisfactory operation of this product. Please
keep these instructions for future reference.
Warnings!
The fitting is class II.
This fitting should be fitted in accordance with IEE Regulations and the Building
Regulations. If in any doubt, or where required by law, consult a competent
person who is registered with an electrical self-certification scheme. Further
information is available online or from your Local Authority.
To prevent electric shock switch off at the mains supply before installing or
maintaining this fitting. Ensure other persons cannot restore the electricity supply
without your knowledge.
If you are in any doubt, please consult a qualified electrician.
If replacing an existing fitting, make a note of the connections.
Always use the correct type and wattage bulb. Never exceed the wattage stated.
When changing a bulb, always switch off at the mains and allow the old bulb to cool
down before handling.
Dispose of used bulbs carefully.
CAUTION! The bulb and surrounding parts can become hot during use.
Care instructions
We recommend cleaning with a soft dry cloth.
Do not use abrasive materials as these will damage the finish.
Indoor use only.
Replace bulbs from John Lewis or established brand of the same type and compatibility.
Parts list
Ensure the house electricity supply is
switched off at the fuse board.
Step 1
Ensure that the bracket (supplied is fixed to a
wall which will support the weight of the
fitting.
Step 2
Connect cables or terminals as shown below:
Check all wires are tight in the terminal
block, and no loose strands are left out.
Cover with insulating tape (not included).
Step 3
Attach wall light to bracket, then attach
crystal chain to main frame. Fit the light bulb
into the lamp holder. The maximum
power indicated must not be
exceeded.
Step 4
Attach aluminium rods to main frame as
shown.
Switch on the electricity supply at the fuse
board.
